[PATCH 20/20] drm/i915: write AVI infoframes for LSPCON
Sharma, Shashank
shashank.sharma at intel.com
Thu Jul 13 05:41:53 UTC 2017
Regards
Shashank
On 7/12/2017 10:54 PM, Ville Syrjälä wrote:
> On Mon, Jul 10, 2017 at 04:48:48PM +0530, Shashank Sharma wrote:
>> LSPCON chips can't pick the HDMI AVI infoframes from direct link.
>> In order to pass AVI infoframes from display controller to LSPCON,
>> we have to write infoframe packets into vendor specified AUX address.
>>
>> Also, LSPCON vendors provide AUX offsets, to inform the LSPCON
>> chip that the AVI IF packets are written, so that the firmware
>> can pick it up and apply.
>>
>> This patch adds function to write AVI infoframes for both MCA as
>> well as Parade Tech LSPCON chips. These two vendors provide different
>> methods for writing infoframes, so this patch contains two different
>> functions, one for each.
> Seems to me that we should also be checking the receiver cap for the
> 444->420 conversion support, and enable it in the PROTOCOL_CONVERTER
> DPCD register. Or are these LSPCON things even ignoring that part of the
> spec?
Yes, LSPCON just needs the YCBCR444 input, and info frames for 420, and
it would take care of
444->420 conversion in FW. Also, its a part of LSPCON specs, that it has
to have 420 output capability.
- Shashank
>
>> Cc: Ville Syrjälä <ville.syrjala at linux.intel.com>
>> Cc: Imre Deak <imre.deak at intel.com>
>> Signed-off-by: Shashank Sharma <shashank.sharma at intel.com>
>> ---
>> drivers/gpu/drm/i915/intel_ddi.c | 8 ++
>> drivers/gpu/drm/i915/intel_drv.h | 3 +
>> drivers/gpu/drm/i915/intel_lspcon.c | 174 ++++++++++++++++++++++++++++++++++++
>> 3 files changed, 185 insertions(+)
>>
>> diff --git a/drivers/gpu/drm/i915/intel_ddi.c b/drivers/gpu/drm/i915/intel_ddi.c
>> index f691710..944d9d5 100644
>> --- a/drivers/gpu/drm/i915/intel_ddi.c
>> +++ b/drivers/gpu/drm/i915/intel_ddi.c
>> @@ -2068,6 +2068,14 @@ void intel_ddi_set_avi_infoframe(struct drm_encoder *encoder,
>> rgb_qrange_limited,
>> rgb_qrange_selectable);
>>
>> + if (crtc_state->lspcon_active) {
>> + struct intel_lspcon *lspcon = enc_to_intel_lspcon(encoder);
>> +
>> + /* LSPCON writes infoframes via AUX */
>> + lspcon->write_infoframe(encoder, crtc_state, &frame);
>> + return;
>> + }
>> +
>> intel_write_infoframe(encoder, crtc_state, &frame);
>> }
>>
>> diff --git a/drivers/gpu/drm/i915/intel_drv.h b/drivers/gpu/drm/i915/intel_drv.h
>> index fad9a53..3e686d2 100644
>> --- a/drivers/gpu/drm/i915/intel_drv.h
>> +++ b/drivers/gpu/drm/i915/intel_drv.h
>> @@ -1079,6 +1079,9 @@ struct intel_lspcon {
>> /* AVI IF setup function for LSPCON */
>> void (*set_infoframes)(struct drm_encoder *encoder,
>> const struct intel_crtc_state *crtc_state);
>> + void (*write_infoframe)(struct drm_encoder *encoder,
>> + const struct intel_crtc_state *crtc_state,
>> + union hdmi_infoframe *frame);
>> };
>>
>> struct intel_digital_port {
>> diff --git a/drivers/gpu/drm/i915/intel_lspcon.c b/drivers/gpu/drm/i915/intel_lspcon.c
>> index 53ddd39..01fddf7 100644
>> --- a/drivers/gpu/drm/i915/intel_lspcon.c
>> +++ b/drivers/gpu/drm/i915/intel_lspcon.c
>> @@ -31,6 +31,18 @@
>> #define LSPCON_VENDOR_PARADE_OUI 0x001CF8
>> #define LSPCON_VENDOR_MCA_OUI 0x0060AD
>>
>> +/* AUX addresses to write AVI IF into */
>> +#define LSPCON_MCA_AVI_IF_WRITE_OFFSET 0x5C0
>> +#define LSPCON_MCA_AVI_IF_CTRL 0x5DF
>> +#define LSPCON_MCA_AVI_IF_KICKOFF (1 << 0)
>> +#define LSPCON_MCA_AVI_IF_HANDLED (1 << 1)
>> +
>> +#define LSPCON_PARADE_AVI_IF_WRITE_OFFSET 0x516
>> +#define LSPCON_PARADE_AVI_IF_CTRL 0x51E
>> +#define LSPCON_PARADE_AVI_IF_KICKOFF (1 << 7)
>> +#define LSPCON_PARADE_AVI_IF_STATUS 0x51F
>> +#define LSPCON_PARADE_AVI_IF_HANDLED (2 << 6)
>> +
>> static struct intel_dp *lspcon_to_intel_dp(struct intel_lspcon *lspcon)
>> {
>> struct intel_digital_port *dig_port =
>> @@ -217,6 +229,167 @@ bool lspcon_ycbcr420_config(struct drm_connector *connector,
>> return false;
>> }
>>
>> +static bool _lspcon_write_infoframe_parade(struct drm_dp_aux *aux,
>> + uint8_t *buffer, ssize_t len)
>> +{
>> + u8 avi_if_ctrl;
>> + u8 avi_if_status;
>> + u8 count = 0;
>> + u8 retry = 5;
>> + u8 avi_buf[8] = {0, };
>> + uint16_t reg;
>> + ssize_t ret;
>> +
>> + while (count++ < 4) {
>> +
>> + do {
>> + /* Is LSPCON FW ready */
>> + reg = LSPCON_PARADE_AVI_IF_CTRL;
>> + ret = drm_dp_dpcd_read(aux, reg, &avi_if_ctrl, 1);
>> + if (ret < 0) {
>> + DRM_ERROR("DPCD read failed, add:0x%x\n", reg);
>> + return false;
>> + }
>> +
>> + if (avi_if_ctrl & LSPCON_PARADE_AVI_IF_KICKOFF)
>> + break;
>> + usleep_range(100, 200);
>> + } while (--retry);
>> +
>> + if (!(avi_if_ctrl & LSPCON_PARADE_AVI_IF_KICKOFF)) {
>> + DRM_ERROR("LSPCON FW not ready for infoframes\n");
>> + return false;
>> + }
>> +
>> + /*
>> + * AVI Infoframe contains 31 bytes of data:
>> + * HB0 to HB2 (3 bytes header)
>> + * PB0 to PB27 (28 bytes data)
>> + * As per Parade spec, while sending first block (8bytes),
>> + * byte 0 is kept for request token no, and byte1 - byte7
>> + * contain frame data. So we have to pack frame like this:
>> + * first block of 8 bytes: <token> <HB0-HB2> <PB0-PB3>
>> + * next 3 blocks: <PB4-PB27>
>> + */
>> + if (count)
>> + memcpy(avi_buf, buffer + count * 8 - 1, 8);
>> + else {
>> + avi_buf[0] = 1;
>> + memcpy(&avi_buf[1], buffer, 7);
>> + }
>> +
>> + /* Write 8 bytes of data at a time */
>> + reg = LSPCON_PARADE_AVI_IF_WRITE_OFFSET;
>> + ret = drm_dp_dpcd_write(aux, reg, avi_buf, 8);
>> + if (ret < 0) {
>> + DRM_ERROR("DPCD write failed, add:0x%x\n", reg);
>> + return false;
>> + }
>> +
>> + /*
>> + * While sending a block of 8 byes, we need to inform block
>> + * number to FW, by programming bits[1:0] of ctrl reg with
>> + * block number
>> + */
>> + avi_if_ctrl = 0x80 + count;
>> + reg = LSPCON_PARADE_AVI_IF_CTRL;
>> + ret = drm_dp_dpcd_write(aux, reg, &avi_if_ctrl, 1);
>> + if (ret < 0) {
>> + DRM_ERROR("DPCD write failed, add:0x%x\n", reg);
>> + return false;
>> + }
>> + }
>> +
>> + /* Check LSPCON FW status */
>> + reg = LSPCON_PARADE_AVI_IF_STATUS;
>> + ret = drm_dp_dpcd_read(aux, reg, &avi_if_status, 1);
>> + if (ret < 0) {
>> + DRM_ERROR("DPCD write failed, address 0x%x\n", reg);
>> + return false;
>> + }
>> +
>> + if (avi_if_status & LSPCON_PARADE_AVI_IF_HANDLED)
>> + DRM_DEBUG_KMS("AVI IF handled by FW\n");
>> +
>> + return true;
>> +}
>> +
>> +static bool _lspcon_write_infoframe_mca(struct drm_dp_aux *aux,
>> + uint8_t *buffer, ssize_t len)
>> +{
>> + int ret;
>> + uint32_t val = 0;
>> + uint16_t reg;
>> + uint8_t *data = buffer;
>> +
>> + reg = LSPCON_MCA_AVI_IF_WRITE_OFFSET;
>> + while (val < len) {
>> + ret = drm_dp_dpcd_write(aux, reg, data, 1);
>> + if (ret < 0) {
>> + DRM_ERROR("DPCD write failed, add:0x%x\n", reg);
>> + return false;
>> + }
>> + val++; reg++; data++;
>> + }
>> +
>> + val = 0;
>> + reg = LSPCON_MCA_AVI_IF_CTRL;
>> + ret = drm_dp_dpcd_read(aux, reg, &val, 1);
>> + if (ret < 0) {
>> + DRM_ERROR("DPCD read failed, address 0x%x\n", reg);
>> + return false;
>> + }
>> +
>> + /* Indicate LSPCON chip about infoframe, clear bit 1 and set bit 0 */
>> + val &= ~LSPCON_MCA_AVI_IF_HANDLED;
>> + val |= LSPCON_MCA_AVI_IF_KICKOFF;
>> +
>> + ret = drm_dp_dpcd_write(aux, reg, &val, 1);
>> + if (ret < 0) {
>> + DRM_ERROR("DPCD read failed, address 0x%x\n", reg);
>> + return false;
>> + }
>> +
>> + val = 0;
>> + ret = drm_dp_dpcd_read(aux, reg, &val, 1);
>> + if (ret < 0) {
>> + DRM_ERROR("DPCD read failed, address 0x%x\n", reg);
>> + return false;
>> + }
>> +
>> + if (val == LSPCON_MCA_AVI_IF_HANDLED)
>> + DRM_DEBUG_KMS("AVI IF handled by FW\n");
>> +
>> + return true;
>> +}
>> +
>> +void lspcon_write_infoframe(struct drm_encoder *encoder,
>> + const struct intel_crtc_state *crtc_state,
>> + union hdmi_infoframe *frame)
>> +{
>> + bool ret;
>> + ssize_t len;
>> + uint8_t buf[VIDEO_DIP_DATA_SIZE];
>> + struct intel_dp *intel_dp = enc_to_intel_dp(encoder);
>> + struct intel_lspcon *lspcon = enc_to_intel_lspcon(encoder);
>> +
>> + len = hdmi_infoframe_pack(frame, buf, sizeof(buf));
>> + if (len < 0) {
>> + DRM_ERROR("Failed to pack AVI IF\n");
>> + return;
>> + }
>> +
>> + if (lspcon->vendor == LSPCON_VENDOR_MCA)
>> + ret = _lspcon_write_infoframe_mca(&intel_dp->aux, buf, len);
>> + else
>> + ret = _lspcon_write_infoframe_parade(&intel_dp->aux, buf, len);
>> +
>> + if (!ret)
>> + DRM_ERROR("Failed to write AVI infoframes\n");
>> + else
>> + DRM_DEBUG_DRIVER("AVI infoframes updated successfully\n");
>> +}
>> +
>> void lspcon_resume(struct intel_lspcon *lspcon)
>> {
>> enum drm_lspcon_mode expected_mode;
>> @@ -282,6 +455,7 @@ bool lspcon_init(struct intel_digital_port *intel_dig_port)
>>
>> connector->ycbcr_420_allowed = true;
>> lspcon->set_infoframes = intel_ddi_set_avi_infoframe;
>> + lspcon->write_infoframe = lspcon_write_infoframe;
>> drm_dp_read_desc(&dp->aux, &dp->desc, drm_dp_is_branch(dp->dpcd));
>>
>> DRM_DEBUG_KMS("Success: LSPCON init\n");
>> --
>> 2.7.4
More information about the dri-devel
mailing list