[PATCH 1/3] drm/msm/hdmi: 8996 PLL: Populate unprepare

[Archit Taneja]

Without doing anything in unprepare, the HDMI driver isn't able to
switch modes successfully. Calling set_rate with a new rate results
in an un-locked PLL.

If we reset the PLL in unprepare, the PLL is able to lock with the
new rate.

Signed-off-by: Archit Taneja <architt at codeaurora.org>
---
 drivers/gpu/drm/msm/hdmi/hdmi_phy_8996.c | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/drivers/gpu/drm/msm/hdmi/hdmi_phy_8996.c b/drivers/gpu/drm/msm/hdmi/hdmi_phy_8996.c
index 143eab46ba68..1fb7645cc721 100644
--- a/drivers/gpu/drm/msm/hdmi/hdmi_phy_8996.c
+++ b/drivers/gpu/drm/msm/hdmi/hdmi_phy_8996.c
@@ -670,6 +670,11 @@ static unsigned long hdmi_8996_pll_recalc_rate(struct clk_hw *hw,
 
 static void hdmi_8996_pll_unprepare(struct clk_hw *hw)
 {
+	struct hdmi_pll_8996 *pll = hw_clk_to_pll(hw);
+	struct hdmi_phy *phy = pll_get_phy(pll);
+
+	hdmi_phy_write(phy, REG_HDMI_8996_PHY_CFG, 0x6);
+	usleep_range(100, 150);
 }
 
 static int hdmi_8996_pll_is_enabled(struct clk_hw *hw)
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
hosted by The Linux Foundation