[PATCH v11 0/3] Add support for the S6E3HA2 panel on TM2 board

[Hoegeun Kwon]

Dear Thierry,

I would like your review please.

I try to modify it to your advice.
Please let me know if you have any other advice.

Best regards,
Hoegeun

On 03/08/2017 10:42 AM, Hoegeun Kwon wrote:
> Dear Thierry,
>
> I understand that your opinion is:
> It is better to handle the error every time it is input to the
> register, rather than error handling at once in the struct using
> error. This not only makes the code easier to maintain, but also
> reduces unnecessary computation.
>
> So I modified the panel driver to code-by-code error handling.
> If this is not your opinion, could you tell me what your opinion?
>
> Best Regards,
> Hoegeun
>
> Changes for V11:
> - Added the Reviewed-by: Javier Martinez Canillas<javier at osg.samsung.com>
>    (1/3, 3/3 patches)
> - Checked for rebase 4.11 rc1.
>
> Changes for V10:
> - Fixed code-by-code error handling.
>
> Changes for V9:
> - Fixed the te-gpio to optional in bindings
>
> Changes for V8:
> - Applied below two patches: (drm/exynos)
>    : drm/exynos: mic: Add mode_set callback function
>    : drm/exynos: mic: Fix parse_dt function
> - The dt-binding patch and driver patch were divided.
> - Rebase these patches on samsung SoC tree[1] and tm2 touckey patch[2].
>
> Change for V7:
> - Fixed the mode_set callback function of mic device driver.
>    because the mic register is initialized when entering suspend
>    mode, so should set the reg value whenever pre_enable is
>    called.
>
> Changes for V6:
> - Fixed the parse_dt function of dsi device driver.
> - Removed OF graph of panel in DT and DT binding document.
> - Fixed the s6e3ha2 panel device driver.
>    - Fixed from number size to ARRAY_SIZE().
>    - Fixed error handling in mipi_dsi_dcs_* functions.
>    - Fixed the clock of display_mode.
>    - Removed unnecessary casting and error log.
>
> Change for V5:
> - The V5 has only one fix in V4 below.
> - Removed the enable check of the mic driver in mode_set
>    callback, because mode_set should be performed every time.
>
> Changes for V4:
> - Removed display-timings in devicetree, the display-timings has
>    been fixed to be provided by the device driver.
> - Added the mode_set callback function into exynos_drm_mic,
>    because the exynos_drm_mic driver can not parse a videomode
>    struct by removing the display-timings from the devicetree.
>
> Changes for V3:
> - In the DT binding document, made it clearly that the panel is a
>    child node of dsi.
> - Fix reset-gpio active from high to low.
> - Is the OF graph saying related to patch2?
>    Althogh the panel is a child of dsi, I think OF graph necessary.
>    because if a remote-endpoint is not specified, the dsi also
>    panel is not probed.
> - The display-timings has been fixed to be provided by the device
>    driver. however, I think display-timings is necessary in dts.
>    because if dts does not have display-timings, dsi will not load.
>
> Changes for V2:
> - Fixed the samsung,s6e3ha2.txt DT document.
>    - Added active high or low after the description of the GPIOs.
>    - Removed the reg and added a description of the virtual
>      channel number of a DSI peripheral.
>
> Depends on:
> [1]https://git.kernel.org/cgit/linux/kernel/git/krzk/linux.git/  (for-next branch)
> [2]https://patchwork.kernel.org/patch/9504131/
>      - ("arm64: dts: exynos: Add tm2 touchkey node")
>
> Hoegeun Kwon (2):
>    dt-bindings: Add support for samsung s6e3ha2 panel binding
>    drm/panel: Add support for S6E3HA2 panel driver on TM2 board
>
> Hyungwon Hwang (1):
>    arm64: dts: exynos: Add support for S6E3HA2 panel device on TM2 board
>
>   .../bindings/display/panel/samsung,s6e3ha2.txt     |  28 +
>   arch/arm64/boot/dts/exynos/exynos5433-tm2.dts      |  12 +
>   drivers/gpu/drm/panel/Kconfig                      |   6 +
>   drivers/gpu/drm/panel/Makefile                     |   1 +
>   drivers/gpu/drm/panel/panel-samsung-s6e3ha2.c      | 739 +++++++++++++++++++++
>   5 files changed, 786 insertions(+)
>   create mode 100644 Documentation/devicetree/bindings/display/panel/samsung,s6e3ha2.txt
>   create mode 100644 drivers/gpu/drm/panel/panel-samsung-s6e3ha2.c
>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.freedesktop.org/archives/dri-devel/attachments/20170321/69cc64e5/attachment.html>