[Intel-gfx] [PATCH v6 3/9] drm/i915: Drop AUX backlight enable check for backlight control
Puthikorn Voravootivat
puthik at chromium.org
Thu May 11 21:01:22 UTC 2017
On Wed, May 10, 2017 at 5:39 PM, Pandiyan, Dhinakaran <
dhinakaran.pandiyan at intel.com> wrote:
> On Tue, 2017-05-09 at 16:40 -0700, Puthikorn Voravootivat wrote:
> > There are some panel that
> > (1) does not support display backlight enable via AUX
> > (2) support display backlight adjustment via AUX
> > (3) support display backlight enable via eDP BL_ENABLE pin
> >
> > The current driver required that (1) must be support to enable (2).
> > This patch drops that requirement.
> >
> > Signed-off-by: Puthikorn Voravootivat <puthik at chromium.org>
> > ---
> > drivers/gpu/drm/i915/intel_dp_aux_backlight.c | 5 ++++-
> > 1 file changed, 4 insertions(+), 1 deletion(-)
> >
> > diff --git a/drivers/gpu/drm/i915/intel_dp_aux_backlight.c
> b/drivers/gpu/drm/i915/intel_dp_aux_backlight.c
> > index 870c03fc0f3a..c22712762957 100644
> > --- a/drivers/gpu/drm/i915/intel_dp_aux_backlight.c
> > +++ b/drivers/gpu/drm/i915/intel_dp_aux_backlight.c
> > @@ -28,6 +28,10 @@ static void set_aux_backlight_enable(struct intel_dp
> *intel_dp, bool enable)
> > {
> > uint8_t reg_val = 0;
> >
> > + /* Early return when display use other mechanism to enable
> backlight. */
> > + if (!(intel_dp->edp_dpcd[1] & DP_EDP_BACKLIGHT_AUX_ENABLE_CAP))
> > + return;
>
> Won't DP_EDP_BACKLIGHT_AUX_ENABLE_CAP be 1 always? The code below, in
> intel_dp_aux_display_control_capable(), makes sure
> DP_EDP_BACKLIGHT_PIN_ENABLE_CAP=0. The spec says at least one of these
> has to be 1.
>
> We will drop the DP_EDP_BACKLIGHT_PIN_ENABLE_CAP != 0 check in next
patch set.
This patch adds check here to prepare for that.
>
> "BACKLIGHT_AUX_ENABLE_CAPABLE
> 1 = Indicates that the Sink device supports display backlight
> enable through the BACKLIGHT_ENABLE bit in the
> EDP_DISPLAY_CONTROL register (DPCD Address 00720h, bit 0).
> Must be set to 1 if the BACKLIGHT_PIN_ENABLE_CAPABLE bit (bit 1)
> is cleared to 0."
>
> -DK
>
> > +
> > if (drm_dp_dpcd_readb(&intel_dp->aux, DP_EDP_DISPLAY_CONTROL_
> REGISTER,
> > ®_val) < 0) {
> > DRM_DEBUG_KMS("Failed to read DPCD register 0x%x\n",
> > @@ -164,7 +168,6 @@ intel_dp_aux_display_control_capable(struct
> intel_connector *connector)
> > * the panel can support backlight control over the aux channel
> > */
> > if (intel_dp->edp_dpcd[1] & DP_EDP_TCON_BACKLIGHT_ADJUSTMENT_CAP
> &&
> > - (intel_dp->edp_dpcd[1] & DP_EDP_BACKLIGHT_AUX_ENABLE_CAP) &&
> > (intel_dp->edp_dpcd[2] & DP_EDP_BACKLIGHT_BRIGHTNESS_AUX_SET_CAP)
> &&
> > !((intel_dp->edp_dpcd[1] & DP_EDP_BACKLIGHT_PIN_ENABLE_CAP) ||
> > (intel_dp->edp_dpcd[2] & DP_EDP_BACKLIGHT_BRIGHTNESS_PWM_PIN_CAP)))
> {
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.freedesktop.org/archives/dri-devel/attachments/20170511/8de4ad20/attachment-0001.html>
More information about the dri-devel
mailing list