[PATCH 06/15] drm/imx: Use drm_mode_get_hv_timing() to populate plane clip rectangle

[Ville Syrjala]

From: Ville Syrjälä <ville.syrjala at linux.intel.com>

Use drm_mode_get_hv_timing() to fill out the plane clip rectangle.

Note that this replaces crtc_state->adjusted_mode usage with
crtc_state->mode. The latter is the correct choice since that's the
mode the user provided and it matches the plane crtc coordinates
the user also provided.

Once everyone agrees on this we can move the clip handling into
drm_atomic_helper_check_plane_state().

Cc: Laurent Pinchart <laurent.pinchart at ideasonboard.com>
Cc: Philipp Zabel <p.zabel at pengutronix.de>
Signed-off-by: Ville Syrjälä <ville.syrjala at linux.intel.com>
---
 drivers/gpu/drm/imx/ipuv3-plane.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/gpu/drm/imx/ipuv3-plane.c b/drivers/gpu/drm/imx/ipuv3-plane.c
index 5a67daedcf4d..c0662503571b 100644
--- a/drivers/gpu/drm/imx/ipuv3-plane.c
+++ b/drivers/gpu/drm/imx/ipuv3-plane.c
@@ -322,7 +322,7 @@ static int ipu_plane_atomic_check(struct drm_plane *plane,
 	struct drm_framebuffer *old_fb = old_state->fb;
 	unsigned long eba, ubo, vbo, old_ubo, old_vbo, alpha_eba;
 	bool can_position = (plane->type == DRM_PLANE_TYPE_OVERLAY);
-	struct drm_rect clip;
+	struct drm_rect clip = {};
 	int hsub, vsub;
 	int ret;
 
@@ -338,10 +338,10 @@ static int ipu_plane_atomic_check(struct drm_plane *plane,
 	if (WARN_ON(!crtc_state))
 		return -EINVAL;
 
-	clip.x1 = 0;
-	clip.y1 = 0;
-	clip.x2 = crtc_state->adjusted_mode.hdisplay;
-	clip.y2 = crtc_state->adjusted_mode.vdisplay;
+	if (crtc_state->enable)
+		drm_mode_get_hv_timing(&crtc_state->mode,
+				       &clip.x2, &clip.y2);
+
 	ret = drm_atomic_helper_check_plane_state(state, crtc_state, &clip,
 						  DRM_PLANE_HELPER_NO_SCALING,
 						  DRM_PLANE_HELPER_NO_SCALING,
-- 
2.13.6