[PATCHv4 3/5] dt-bindings: document the CEC GPIO bindings

[Hans Verkuil]

Ping!

Still waiting for an Ack from the devicetree devs so this can be merged for 4.15.

Regards,

	Hans

On 08/31/2017 01:01 PM, Hans Verkuil wrote:
> From: Hans Verkuil <hans.verkuil at cisco.com>
> 
> Document the bindings for the cec-gpio module for hardware where the
> CEC line and optionally the HPD line are connected to GPIO lines.
> 
> Signed-off-by: Hans Verkuil <hans.verkuil at cisco.com>
> ---
>  .../devicetree/bindings/media/cec-gpio.txt         | 22 ++++++++++++++++++++++
>  1 file changed, 22 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/media/cec-gpio.txt
> 
> diff --git a/Documentation/devicetree/bindings/media/cec-gpio.txt b/Documentation/devicetree/bindings/media/cec-gpio.txt
> new file mode 100644
> index 000000000000..db20a7452dbd
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/media/cec-gpio.txt
> @@ -0,0 +1,22 @@
> +* HDMI CEC GPIO driver
> +
> +The HDMI CEC GPIO module supports CEC implementations where the CEC line
> +is hooked up to a pull-up GPIO line and - optionally - the HPD line is
> +hooked up to another GPIO line.
> +
> +Required properties:
> +  - compatible: value must be "cec-gpio"
> +  - cec-gpio: gpio that the CEC line is connected to
> +
> +Optional property:
> +  - hpd-gpio: gpio that the HPD line is connected to
> +
> +Example for the Raspberry Pi 3 where the CEC line is connected to
> +pin 26 aka BCM7 aka CE1 on the GPIO pin header and the HPD line is
> +connected to pin 11 aka BCM17:
> +
> +cec-gpio at 7 {
> +       compatible = "cec-gpio";
> +       cec-gpio = <&gpio 7 GPIO_OPEN_DRAIN>;
> +       hpd-gpio = <&gpio 17 GPIO_ACTIVE_HIGH>;
> +};
>