[PATCH V5 8/8] backlight: qcom-wled: Add auto string detection logic

[kgunda at codeaurora.org]

On 2018-08-27 20:24, Bjorn Andersson wrote:
> On Fri 24 Aug 03:27 PDT 2018, Kiran Gunda wrote:
>> diff --git a/drivers/video/backlight/qcom-wled.c 
>> b/drivers/video/backlight/qcom-wled.c
> [..]
>>  struct wled {
>> @@ -135,16 +146,22 @@ struct wled {
>>  	struct regmap *regmap;
>>  	struct mutex lock;	/* Lock to avoid race from thread irq handler */
>>  	ktime_t last_short_event;
>> +	ktime_t start_ovp_fault_time;
>>  	u16 ctrl_addr;
>>  	u16 sink_addr;
>>  	u16 max_string_count;
>> +	u16 auto_detection_ovp_count;
>>  	u32 brightness;
>>  	u32 max_brightness;
>>  	u32 short_count;
>> +	u32 auto_detect_count;
>>  	bool disabled_by_short;
>>  	bool has_short_detect;
>> +	int ovp_irq;
>> +	bool ovp_irq_disabled;
> 
> ovp_irq_disabled is now only assigned, never read. So you should be 
> able
> to drop it.
> 
Ok. will address in next series.
> [..]
>> @@ -200,7 +226,18 @@ static int wled_module_enable(struct wled *wled, 
>> int val)
>>  				WLED_CTRL_REG_MOD_EN,
>>  				WLED_CTRL_REG_MOD_EN_MASK,
>>  				val << WLED_CTRL_REG_MOD_EN_SHIFT);
>> -	return rc;
>> +	if (rc < 0)
>> +		return rc;
>> +
>> +	if (val) {
>> +		schedule_delayed_work(&wled->ovp_work, HZ / 100);
> 
> wled_ovp_work() is a nop when ovp_irq == 0, so wrap the entire if/else
> in a check for ovp_irq > 0 (rather than include it in the else) and 
> drop
> it from the worker.
> 
Will address in next series.
>> +	} else {
>> +		if (!cancel_delayed_work_sync(&wled->ovp_work) &&
>> +		    wled->ovp_irq > 0)
>> +			disable_irq(wled->ovp_irq);
>> +	}
>> +
>> +	return 0;
> 
> Also, if a user calls rmmod within 10ms of enabling module we will
> schedule work of code that's no longer available in the kernel. So you
> need to also cancel_delayed_work_sync() in the remove function of the
> driver.
> 
> 
Will address in next series.
> Apart from this I think this patch looks good now!
> 
Thank you
> Regards,
> Bjorn