[PATCH v6] arm64: dts: qcom: sdm845: Add dpu to sdm845 dts file

[Doug Anderson]

Hi,

On Tue, Dec 4, 2018 at 3:54 PM Jeykumar Sankaran <jsanka at codeaurora.org> wrote:
>
> DPU is short for the Display Processing Unit. It is the display
> controller on Qualcomm SDM845 chips.
>
> This change adds MDSS and DSI nodes to enable display on the
> target device.
>
> Changes in v2:
>          - Beefed up commit message
>          - Use SoC specific compatibles for mdss and dpu (Rob H)
>          - Use assigned-clocks to set initial clock frequency(Rob H)
> Changes in v3:
>          - added IOMMU node
>          - Fix device naming (remove _phys)
>          - Use correct IRQ_TYPE in interrupt specifiers
> Changes in v4:
>          - move mdss node to preserve the unit address sort order
>          - remove _clk suffix from dsi clocks
>          (both the comments are from Doug Anderson)
> Changes in v5:
>         - Keep the device status "disabled" by default (Bjorn Andersson)
>         - Use MDSS_GDSC macro (Jordan)
>         - Fix phy-names (Jordan)
>         - List reg ranges in numerical order (Jordan)
> Changes in v6:
>         - Separating this patch out of the series
>         - fix phy-names
>
> Signed-off-by: Jeykumar Sankaran <jsanka at codeaurora.org>
> Signed-off-by: Sean Paul <seanpaul at chromium.org>
> ---
>  arch/arm64/boot/dts/qcom/sdm845.dtsi | 203 +++++++++++++++++++++++++++++++++++
>  1 file changed, 203 insertions(+)

With my admittedly limited understanding of the device tree for
graphics, this looks good to me.

Reviewed-by: Douglas Anderson <dianders at chromium.org>

...this works for me on sdm845-cheza.  Specifically I tested it on our
4.19 branch which has some display backports and a few picks from the
mailing list.  Anyone specifically interested in the tree I tested
with can see https://crrev.com/c/1327901, which includes this patch.
Thus:

Tested-by: Douglas Anderson <dianders at chromium.org>