[PATCH 3/5] drm/bridge: ti-tfp410: Set connector type based on DT connector node

[Laurent Pinchart]

The TI TFP410 is a DVI encoder, not a full HDMI encoder. Its output can
be routed to a DVI-D connector, even if in many cases embedded systems
will use an HDMI connector to carry the DVI signals.

Instead of hardcoding the connector type to HDMI, retrieve the connector
type from its DT node.

Signed-off-by: Laurent Pinchart <laurent.pinchart at ideasonboard.com>
---
 drivers/gpu/drm/bridge/ti-tfp410.c | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/drivers/gpu/drm/bridge/ti-tfp410.c b/drivers/gpu/drm/bridge/ti-tfp410.c
index c3e32138c6bb..e4280f5af9f5 100644
--- a/drivers/gpu/drm/bridge/ti-tfp410.c
+++ b/drivers/gpu/drm/bridge/ti-tfp410.c
@@ -27,6 +27,7 @@
 struct tfp410 {
 	struct drm_bridge	bridge;
 	struct drm_connector	connector;
+	unsigned int		connector_type;
 
 	struct i2c_adapter	*ddc;
 	struct gpio_desc	*hpd;
@@ -126,7 +127,7 @@ static int tfp410_attach(struct drm_bridge *bridge)
 	drm_connector_helper_add(&dvi->connector,
 				 &tfp410_con_helper_funcs);
 	ret = drm_connector_init(bridge->dev, &dvi->connector,
-				 &tfp410_con_funcs, DRM_MODE_CONNECTOR_HDMIA);
+				 &tfp410_con_funcs, dvi->connector_type);
 	if (ret) {
 		dev_err(dvi->dev, "drm_connector_init() failed: %d\n", ret);
 		return ret;
@@ -172,6 +173,11 @@ static int tfp410_get_connector_properties(struct tfp410 *dvi)
 	if (!connector_node)
 		return -ENODEV;
 
+	if (of_device_is_compatible(connector_node, "hdmi-connector"))
+		dvi->connector_type = DRM_MODE_CONNECTOR_HDMIA;
+	else
+		dvi->connector_type = DRM_MODE_CONNECTOR_DVID;
+
 	dvi->hpd = fwnode_get_named_gpiod(&connector_node->fwnode,
 					"hpd-gpios", 0, GPIOD_IN, "hpd");
 	if (IS_ERR(dvi->hpd)) {
-- 
Regards,

Laurent Pinchart