[PATCH v2] drm/mxsfb: Fix runtime PM for unpowering lcdif block

[Leonard Crestez]

On Tue, 2018-07-31 at 13:54 +0200, Philipp Zabel wrote:
> On Tue, 2018-07-17 at 13:48 +0300, Leonard Crestez wrote:
> > Adding lcdif nodes to a power domain currently does work, it results in
> > black/corrupted screens or hangs. While the driver does enable runtime
> > pm it does not deal correctly with the block being unpowered.
> > 
> > Ensure power is on when required by adding pm_runtime_get/put_sync to
> > mxsfb_pipe_enable/disable.
> > 
> > Since power is lost on suspend implement PM_SLEEP_OPS using
> > drm_mode_config_helper_suspend/resume.
> > 
> > The mxsfb_plane_atomic_update function can get called before
> > mxsfb_pipe_enable while the block is not yet powered. When this happens
> > the write to LCDIF_NEXT_BUF is lost causing corrupt display on unblank
> > until a refresh.
> 
> Why does this happen?

I'm not sure what you're asking but register writes to unpowered or
unclocked blocks are not expected to "just work". Here the write is
ignored/lost but I think on imx8 it can even cause a bus error.

The approach here is to only set the framebuffer address as part of
activating the display.

> > Fix this by not writing gem->paddr if the block is not enabled and
> > instead delaying the write until the next mxsfb_crtc_mode_set_nofb call.
> > At that point also update cur_buf to avoid an initial corrupt frame
> > after resume.
> > 
> > Signed-off-by: Leonard Crestez <leonard.crestez at nxp.com>
> 
> Tested-by: Philipp Zabel <p.zabel at pengutronix.de>
> 
> on imx6ull-evk, this fixes the initial corrupt frame.

Cool!