[PATCH v12 5/5] dt-bindings: drm/panel: Document Innolux TV123WAM panel bindings

[Andrzej Hajda]

On 21.06.2018 14:32, Sandeep Panda wrote:
> Innolux TV123WAM is a 12.3" eDP display panel with
> 2160x1440 resolution, which can be supported by simple
> panel driver.

Are you sure this is Innolux? Quick grep on Internet finds only BOE
panel with this TV123WAM[1].

[1]:
https://e2e.ti.com/cfs-file/__key/communityserver-discussions-components-files/138/TV123WAM_2D00_ND0_5F00_Product-spec_5F00_BOE_5F00_20161115_2D00_A00.pdf

Regards
Andrzej
>
> Changes in v1:
>  - Make use of simple panel driver instead of creating
>    a new driver for this panel (Sean Paul).
>  - Combine dt-binding and driver changes into one patch
>    as done by other existing panel support changes.
>
> Changes in v2:
>  - Separate driver change from dt-binding documentation (Rob Herring).
>  - Add the properties from simple-panel binding that are applicable to
>    this panel (Rob Herring).
>
> Signed-off-by: Sandeep Panda <spanda at codeaurora.org>
> Reviewed-by: Rob Herring <robh at kernel.org>
> ---
>  .../bindings/display/panel/innolux,tv123wam.txt      | 20 ++++++++++++++++++++
>  1 file changed, 20 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/display/panel/innolux,tv123wam.txt
>
> diff --git a/Documentation/devicetree/bindings/display/panel/innolux,tv123wam.txt b/Documentation/devicetree/bindings/display/panel/innolux,tv123wam.txt
> new file mode 100644
> index 000000000000..a9b35265fa13
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/display/panel/innolux,tv123wam.txt
> @@ -0,0 +1,20 @@
> +Innolux TV123WAM 12.3 inch eDP 2K display panel
> +
> +This binding is compatible with the simple-panel binding, which is specified
> +in simple-panel.txt in this directory.
> +
> +Required properties:
> +- compatible: should be "innolux,tv123wam"
> +- power-supply: regulator to provide the supply voltage
> +
> +Optional properties:
> +- enable-gpios: GPIO pin to enable or disable the panel
> +- backlight: phandle of the backlight device attached to the panel
> +
> +Example:
> +	panel_edp: panel-edp {
> +		compatible = "innolux,tv123wam";
> +		enable-gpios = <&msmgpio 31 GPIO_ACTIVE_LOW>;
> +		power-supply = <&pm8916_l2>;
> +		backlight = <&backlight>;
> +	};