[PATCH v2 02/11] drm/i915/psr: Don't tell sink that main link will be active while is active PSR2

[Dhinakaran Pandiyan]

On Thu, 2018-11-29 at 18:25 -0800, José Roberto de Souza wrote:
> For PSR2 there is no register to tell HW to keep main link enabled
Right, there is no bit in PSR2_CTL
Reviewed-by: Dhinakaran Pandiyan <dhinakaran.pandiyan at intel.com>


> while PSR2 is active, so don't configure sink DPCD with a
> misleading value.
> 
> v2: Moving the set of DP_PSR_CRC_VERIFICATION to the else block
> of 'if (dev_priv->psr.psr2_enabled)' to another patch. (Rodrigo)
> 
> Cc: Dhinakaran Pandiyan <dhinakaran.pandiyan at intel.com>
> Cc: Rodrigo Vivi <rodrigo.vivi at intel.com>
> Signed-off-by: José Roberto de Souza <jose.souza at intel.com>
> ---
>  drivers/gpu/drm/i915/intel_psr.c | 5 +++--
>  1 file changed, 3 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/gpu/drm/i915/intel_psr.c
> b/drivers/gpu/drm/i915/intel_psr.c
> index 40ca6cc43cc4..8515f4a6f4f1 100644
> --- a/drivers/gpu/drm/i915/intel_psr.c
> +++ b/drivers/gpu/drm/i915/intel_psr.c
> @@ -395,10 +395,11 @@ static void intel_psr_enable_sink(struct
> intel_dp *intel_dp)
>  		drm_dp_dpcd_writeb(&intel_dp->aux,
> DP_RECEIVER_ALPM_CONFIG,
>  				   DP_ALPM_ENABLE);
>  		dpcd_val |= DP_PSR_ENABLE_PSR2;
> +	} else {
> +		if (dev_priv->psr.link_standby)
> +			dpcd_val |= DP_PSR_MAIN_LINK_ACTIVE;
>  	}
>  
> -	if (dev_priv->psr.link_standby)
> -		dpcd_val |= DP_PSR_MAIN_LINK_ACTIVE;
>  	if (!dev_priv->psr.psr2_enabled && INTEL_GEN(dev_priv) >= 8)
>  		dpcd_val |= DP_PSR_CRC_VERIFICATION;
>  	drm_dp_dpcd_writeb(&intel_dp->aux, DP_PSR_EN_CFG, dpcd_val);