[PATCH 08/12] arm64: dts: allwinner: h6: Add MMC1 pins
Ondřej Jirman
megous at megous.com
Mon Apr 8 22:41:05 UTC 2019
On Mon, Apr 08, 2019 at 09:43:27AM +0200, Maxime Ripard wrote:
> On Sat, Apr 06, 2019 at 01:45:10AM +0200, megous at megous.com wrote:
> > From: Ondrej Jirman <megous at megous.com>
> >
> > ---
> > arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi | 9 +++++++++
> > 1 file changed, 9 insertions(+)
> >
> > diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi
> > index 91fecab58836..dccad79da90c 100644
> > --- a/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi
> > +++ b/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi
> > @@ -238,6 +238,15 @@
> > bias-pull-up;
> > };
> >
> > +
>
> Extra line
>
> > + mmc1_pins: mmc1-pins {
> > + pins = "PG0", "PG1", "PG2", "PG3",
> > + "PG4", "PG5";
> > + function = "mmc1";
> > + drive-strength = <30>;
> > + bias-pull-up;
> > + };
> > +
>
> Is that the only muxing option?
I don't think so. I believe someone can use a 1-bit interface (bus-width = <1>),
and then some data pins will be free. This pinconfig is for 4-bit bus width
setup.
Though other SoCs (ex. H3, A83T) don't consider this possibility and make the
4-bit config the default pinctrl for mmc1. To add to the confusion, on these
SoCs 4-bit pinconf is the default, but 1bit bus-width is the (implicit) default.
This led to some confusion in the past.
So we can either:
- keep consistency with what is done elsewhere, and make this default, despite
not being the only option,
- or perhaps I can rename this to mmc1_bus_width4_pins, or somesuch, to make it
more explicit, and keep it non-default.
What do you think is better?
thank you and regards,
o.
> If so, then it should be assigned by default to mmc1
>
> Thanks!
> Maxime
>
> --
> Maxime Ripard, Bootlin
> Embedded Linux and Kernel engineering
> https://bootlin.com
More information about the dri-devel
mailing list