[PATCH v5 1/4] dt-bindings: display: mediatek: update dpi supported chips
Jitao Shi
jitao.shi at mediatek.com
Wed Aug 7 06:02:54 UTC 2019
Add decriptions about supported chips, including MT2701 & MT8173 &
mt8183
Signed-off-by: Jitao Shi <jitao.shi at mediatek.com>
---
.../bindings/display/mediatek/mediatek,dpi.txt | 11 +++++++++++
1 file changed, 11 insertions(+)
diff --git a/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt b/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt
index b6a7e7397b8b..cd6a1469c8b7 100644
--- a/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt
+++ b/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt
@@ -7,6 +7,7 @@ output bus.
Required properties:
- compatible: "mediatek,<chip>-dpi"
+ the supported chips are mt2701 , mt8173 and mt8183.
- reg: Physical base address and length of the controller's registers
- interrupts: The interrupt signal from the function block.
- clocks: device clocks
@@ -16,6 +17,11 @@ Required properties:
Documentation/devicetree/bindings/graph.txt. This port should be connected
to the input port of an attached HDMI or LVDS encoder chip.
+Optional properties:
+- dpi_pin_mode_swap: Swap the pin mode between dpi mode and gpio mode.
+- pinctrl-names: Contain "gpiomode" and "dpimode".
+- dpi_dual_edge: Control the RGB 24bit data on 12 pins or 24 pins.
+
Example:
dpi0: dpi at 1401d000 {
@@ -26,6 +32,11 @@ dpi0: dpi at 1401d000 {
<&mmsys CLK_MM_DPI_ENGINE>,
<&apmixedsys CLK_APMIXED_TVDPLL>;
clock-names = "pixel", "engine", "pll";
+ dpi_dual_edge;
+ dpi_pin_mode_swap;
+ pinctrl-names = "gpiomode", "dpimode";
+ pinctrl-0 = <&dpi_pin_gpio>;
+ pinctrl-1 = <&dpi_pin_func>;
port {
dpi0_out: endpoint {
--
2.21.0
More information about the dri-devel
mailing list