[PATCH v8 4/4] arm64: dts: allwinner: orange-pi-3: Enable HDMI output
megous at megous.com
megous at megous.com
Tue Aug 6 15:57:43 UTC 2019
From: Ondrej Jirman <megous at megous.com>
Orange Pi 3 has a DDC_CEC_EN signal connected to PH2, that enables the DDC
I2C bus voltage shifter. Before EDID can be read, we need to pull PH2 high.
This is realized by the ddc-en-gpios property.
Signed-off-by: Ondrej Jirman <megous at megous.com>
---
.../dts/allwinner/sun50i-h6-orangepi-3.dts | 26 +++++++++++++++++++
1 file changed, 26 insertions(+)
diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi-3.dts b/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi-3.dts
index 2c6807b74ff6..01bb1bafe284 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi-3.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi-3.dts
@@ -22,6 +22,18 @@
stdout-path = "serial0:115200n8";
};
+ connector {
+ compatible = "hdmi-connector";
+ ddc-en-gpios = <&pio 7 2 GPIO_ACTIVE_HIGH>; /* PH2 */
+ type = "a";
+
+ port {
+ hdmi_con_in: endpoint {
+ remote-endpoint = <&hdmi_out_con>;
+ };
+ };
+ };
+
leds {
compatible = "gpio-leds";
@@ -72,6 +84,10 @@
cpu-supply = <®_dcdca>;
};
+&de {
+ status = "okay";
+};
+
&ehci0 {
status = "okay";
};
@@ -91,6 +107,16 @@
status = "okay";
};
+&hdmi {
+ status = "okay";
+};
+
+&hdmi_out {
+ hdmi_out_con: endpoint {
+ remote-endpoint = <&hdmi_con_in>;
+ };
+};
+
&mdio {
ext_rgmii_phy: ethernet-phy at 1 {
compatible = "ethernet-phy-ieee802.3-c22";
--
2.22.0
More information about the dri-devel
mailing list