[PATCH 1/4] ARM: dts: am437x-gp-evm: add HDMI support

[Laurent Pinchart]

Hi Tomi,

On Fri, Dec 13, 2019 at 02:04:30PM +0200, Tomi Valkeinen wrote:
> On 13/12/2019 13:42, Laurent Pinchart wrote:
> > On Fri, Dec 13, 2019 at 12:56:31PM +0200, Tomi Valkeinen wrote:
> >> On 13/12/2019 12:42, Laurent Pinchart wrote:
> >>
> >>>> I think the correct way would be to have DRM framework understand that we have two displays, which
> >>>> are mutually exclusive, and the display pipeline drivers would have the means to switch the gpio.
> >>>> And that the display setup could be communicated properly to the userspace, and the userspace would
> >>>> understand it. I don't think any of those exists.
> >>>
> >>> Isn't this what possible_clones in drm_encoder is for ? It notifies
> >>> userspace of mutual exclusions between encoders.
> >>
> >> Hmm, how would that work here? Isn't encoder cloning about having two encoders, which take the input
> >> from the same video source, and then outputting to two displays?
> > 
> > That's the idea. If you have one encoder for HDMI and one for the panel,
> > you can mark them as non-clonable, and then only one of the two can be
> > active at a time.
> 
> We have a single DPI output from the SoC. That goes to the panel, or to SiI9022 bridge, depending on 
> the GPIO switch.
> 
> So... In the DT file, we would have multiple endpoints in the same output port in DSS, one going to 
> the panel, one to the SiI9022? omapdrm could then create two encoders, one abstracting the DPI 
> output and the connection to the panel, one abstracting the DPI output and SiI9022?

That's the idea, yes.

> And then someone would need to handle the GPIO, and set it based on the output used. These kind of 
> gpios are always difficult, as they don't belong anywhere =).

https://lore.kernel.org/lkml/20191211061911.238393-5-hsinyi@chromium.org/

Still, the infrastructure in omapdrm would need quite a bit of work.
We're just about to get a helper layer for linear pipelines merged, and
we already need to go one step further :-)

-- 
Regards,

Laurent Pinchart