[PATCH 1/2] drm/i915/dsi: Remove readback of panel orientation on BYT / CHT

[Ville Syrjälä]

On Sun, Dec 15, 2019 at 10:33:06PM +0100, Hans de Goede wrote:
> Commit 82daca297506 ("drm/i915: Add "panel orientation" property to the
> panel connector, v6.") uses hardware state readback to determine if the
> GOP is rotating the image by 180 degrees to compensate for upside-down
> mounted panels.
> 
> When I wrote that commit I tried to find the VBT bits the GOP used to
> decide to rotate the image, but I could not find them. Back then I only
> looked at the rotation bits in struct mipi_config and these read 0 on
> the 1 BYT device I have with an upside-down mounted panel
> (a GP-electronic T701 tablet). While working on a similar problem on a
> BYT device with an eDP panel I noticed that the new
> intel_dsi_get_panel_orientation() helper which gets used on newer
> SoCs (Apollo-Lake, etc.) checks the rotate_180 bit in the
> BDB_GENERAL_FEATURES VBT block.
> 
> I've checked and this bit indeed is set on the GP-electronic T701 tablet,
> so using the generic intel_dsi_get_panel_orientation() helper there does
> the right thing without needing any extra readback of hw state.
> 
> This commit removes the special handling of the panel orientation for
> DSI panels on BYT/CHT devices, bringing the handling in line with the
> handling of DSI panels on other devices.
> 
> Signed-off-by: Hans de Goede <hdegoede at redhat.com>

Same as
https://patchwork.freedesktop.org/patch/257787/?series=51274&rev=4
which I apparently never pushed. But feel free to go with your version
since you have more meat in the commit msg.

Reviewed-by: Ville Syrjälä <ville.syrjala at linux.intel.com>

> ---
>  drivers/gpu/drm/i915/display/vlv_dsi.c | 55 +-------------------------
>  1 file changed, 1 insertion(+), 54 deletions(-)
> 
> diff --git a/drivers/gpu/drm/i915/display/vlv_dsi.c b/drivers/gpu/drm/i915/display/vlv_dsi.c
> index 0ca49b1604c6..18f7616e6c27 100644
> --- a/drivers/gpu/drm/i915/display/vlv_dsi.c
> +++ b/drivers/gpu/drm/i915/display/vlv_dsi.c
> @@ -1563,59 +1563,6 @@ static const struct drm_connector_funcs intel_dsi_connector_funcs = {
>  	.atomic_duplicate_state = intel_digital_connector_duplicate_state,
>  };
>  
> -static enum drm_panel_orientation
> -vlv_dsi_get_hw_panel_orientation(struct intel_connector *connector)
> -{
> -	struct drm_i915_private *dev_priv = to_i915(connector->base.dev);
> -	struct intel_encoder *encoder = connector->encoder;
> -	enum intel_display_power_domain power_domain;
> -	enum drm_panel_orientation orientation;
> -	struct intel_plane *plane;
> -	struct intel_crtc *crtc;
> -	intel_wakeref_t wakeref;
> -	enum pipe pipe;
> -	u32 val;
> -
> -	if (!encoder->get_hw_state(encoder, &pipe))
> -		return DRM_MODE_PANEL_ORIENTATION_UNKNOWN;
> -
> -	crtc = intel_get_crtc_for_pipe(dev_priv, pipe);
> -	plane = to_intel_plane(crtc->base.primary);
> -
> -	power_domain = POWER_DOMAIN_PIPE(pipe);
> -	wakeref = intel_display_power_get_if_enabled(dev_priv, power_domain);
> -	if (!wakeref)
> -		return DRM_MODE_PANEL_ORIENTATION_UNKNOWN;
> -
> -	val = I915_READ(DSPCNTR(plane->i9xx_plane));
> -
> -	if (!(val & DISPLAY_PLANE_ENABLE))
> -		orientation = DRM_MODE_PANEL_ORIENTATION_UNKNOWN;
> -	else if (val & DISPPLANE_ROTATE_180)
> -		orientation = DRM_MODE_PANEL_ORIENTATION_BOTTOM_UP;
> -	else
> -		orientation = DRM_MODE_PANEL_ORIENTATION_NORMAL;
> -
> -	intel_display_power_put(dev_priv, power_domain, wakeref);
> -
> -	return orientation;
> -}
> -
> -static enum drm_panel_orientation
> -vlv_dsi_get_panel_orientation(struct intel_connector *connector)
> -{
> -	struct drm_i915_private *dev_priv = to_i915(connector->base.dev);
> -	enum drm_panel_orientation orientation;
> -
> -	if (IS_VALLEYVIEW(dev_priv) || IS_CHERRYVIEW(dev_priv)) {
> -		orientation = vlv_dsi_get_hw_panel_orientation(connector);
> -		if (orientation != DRM_MODE_PANEL_ORIENTATION_UNKNOWN)
> -			return orientation;
> -	}
> -
> -	return intel_dsi_get_panel_orientation(connector);
> -}
> -
>  static void vlv_dsi_add_properties(struct intel_connector *connector)
>  {
>  	struct drm_i915_private *dev_priv = to_i915(connector->base.dev);
> @@ -1633,7 +1580,7 @@ static void vlv_dsi_add_properties(struct intel_connector *connector)
>  		connector->base.state->scaling_mode = DRM_MODE_SCALE_ASPECT;
>  
>  		connector->base.display_info.panel_orientation =
> -			vlv_dsi_get_panel_orientation(connector);
> +			intel_dsi_get_panel_orientation(connector);
>  		drm_connector_init_panel_orientation_property(
>  				&connector->base,
>  				connector->panel.fixed_mode->hdisplay,
> -- 
> 2.23.0

-- 
Ville Syrjälä
Intel