[PATCH v3 00/16] drm/tegra: Fix IOVA space on Tegra186 and later

[Dmitry Osipenko]

01.02.2019 16:28, Thierry Reding пишет:
> From: Thierry Reding <treding at nvidia.com>
> 
> Tegra186 and later are different from earlier generations in that they
> use an ARM SMMU rather than the Tegra SMMU. The ARM SMMU driver behaves
> slightly differently in that the geometry for IOMMU domains is set only
> after a device was attached to it. This is to make sure that the SMMU
> instance that the domain belongs to is known, because each instance can
> have a different input address space (i.e. geometry).
> 
> Work around this by moving all IOVA allocations to a point where the
> geometry of the domain is properly initialized.
> 
> This second version of the series addresses all review comments and adds
> a number of patches that will actually allow host1x to work with an SMMU
> enabled on Tegra186. The patches also add programming required to
> address the full 40 bits of address space.
> 
> The third version of the series fixes the 40-bit addressing code by
> making sure that wide opcodes are always written atomically to the push
> buffer. Another pair of patches are introduced to fix a long-standing
> bug where the HOST1X_CHANNEL_DMAEND register wasn't properly programmed
> and one push buffer memory optimization that avoid wasting almost one
> full memory page per push buffer.
> 
> This supersedes the following patch:
> 
> 	https://patchwork.kernel.org/patch/10775579/
> 
> Thierry
> 
> Thierry Reding (16):
>   gpu: host1x: Set up stream ID table
>   gpu: host1x: Program the channel stream ID
>   gpu: host1x: Introduce support for wide opcodes
>   gpu: host1x: Support 40-bit addressing
>   gpu: host1x: Use direct DMA with IOMMU API usage
>   gpu: host1x: Restrict IOVA space to DMA mask
>   gpu: host1x: Support 40-bit addressing on Tegra186
>   gpu: host1x: Use correct semantics for HOST1X_CHANNEL_DMAEND
>   gpu: host1x: Optimize CDMA push buffer memory usage
>   drm/tegra: Store parent pointer in Tegra DRM clients
>   drm/tegra: vic: Load firmware on demand
>   drm/tegra: Setup shared IOMMU domain after initialization
>   drm/tegra: Restrict IOVA space to DMA mask
>   drm/tegra: vic: Do not clear driver data
>   drm/tegra: vic: Support stream ID register programming
>   arm64: tegra: Enable SMMU for VIC on Tegra186
> 
>  arch/arm64/boot/dts/nvidia/tegra186.dtsi    |   1 +
>  drivers/gpu/drm/tegra/drm.c                 |  57 +++++----
>  drivers/gpu/drm/tegra/drm.h                 |   1 +
>  drivers/gpu/drm/tegra/vic.c                 |  75 ++++++++---
>  drivers/gpu/drm/tegra/vic.h                 |   9 ++
>  drivers/gpu/host1x/cdma.c                   | 132 ++++++++++++++++++--
>  drivers/gpu/host1x/cdma.h                   |   2 +
>  drivers/gpu/host1x/dev.c                    |  49 +++++++-
>  drivers/gpu/host1x/dev.h                    |   8 ++
>  drivers/gpu/host1x/hw/cdma_hw.c             |  32 ++++-
>  drivers/gpu/host1x/hw/channel_hw.c          |  42 ++++++-
>  drivers/gpu/host1x/hw/host1x06_hardware.h   |   6 +
>  drivers/gpu/host1x/hw/host1x07_hardware.h   |   6 +
>  drivers/gpu/host1x/hw/hw_host1x06_channel.h |  11 ++
>  drivers/gpu/host1x/hw/hw_host1x07_channel.h |  11 ++
>  include/trace/events/host1x.h               |  26 ++++
>  16 files changed, 404 insertions(+), 64 deletions(-)
>  create mode 100644 drivers/gpu/host1x/hw/hw_host1x06_channel.h
>  create mode 100644 drivers/gpu/host1x/hw/hw_host1x07_channel.h
> 

I gave a test to this series on T20 and T30. Opentegra works, grate tests work, glxgears are spinning.. everything working fine.