[PATCH 0/5] tda998x updates

[Russell King - ARM Linux admin]

On Fri, Jan 25, 2019 at 09:40:38AM +0000, Russell King - ARM Linux admin wrote:
> Hi,
> 
> This series adds support for programming the SPD and vendor infoframes.
> 
> It also adds support for pixel repeated modes - we were not rejecting
> these modes, but we also didn't have the implementation to support
> them.  As their implementation is simple, add it rather than rejecting
> the modes.
> 
> Support is also added for the bridge timing information, that upstream
> components may wish to use to adjust their output appropriately.
> 
> Lastly, rather than merely passing through the full-range RGB from the
> CRTC, adapt the RGB range to the capabilities of the display and the
> default range for the mode.  This means that if the display does not
> support the Q bit in the video infoframe, and the mode is defined to
> have limited range RGB, we will compress the output RGB range to
> limited range.
> 
> Tested on 4.20 with a Panasonic TV.
> 
>       drm/i2c: tda998x: add support for pixel repeated modes
>       drm/i2c: tda998x: add bridge timing information
>       drm/i2c: tda998x: add support for writing SPD
>       drm/i2c: tda998x: add vendor specific infoframe support
>       drm/i2c: tda998x: improve correctness of quantisation range
> 
>  drivers/gpu/drm/i2c/tda998x_drv.c | 120 +++++++++++++++++++++++++++++++++-----
>  1 file changed, 105 insertions(+), 15 deletions(-)

Hi,

>From what I can tell, patches 1 and 2 have not received any comments.
Should I assume that these are fine to go to David?

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTC broadband for 0.8mile line in suburbia: sync at 12.1Mbps down 622kbps up
According to speedtest.net: 11.9Mbps down 500kbps up