[PATCH 1/3] RFT: drm/pl111: Support grayscale

[Fabian Vogt]

Hi,

I gave the series a try (virtual CX and TP so far, will do on a real CX later):
OOPS with a nullptr deref during probe.
This diff which just moves some lines around fixes that and the LCD appears to
work properly.

Once I verified the 24bit depth and clock speed config on HW as well, I can
give you my Tested-by, or would you prefer that I resubmit your series with the
fix below?

Thanks,
Fabian

---
diff --git a/drivers/gpu/drm/pl111/pl111_display.c b/drivers/gpu/drm/pl111/pl111_display.c
index 587b4d148c18..bd84d7a5a0f4 100644
--- a/drivers/gpu/drm/pl111/pl111_display.c
+++ b/drivers/gpu/drm/pl111/pl111_display.c
@@ -133,10 +133,6 @@ static void pl111_display_enable(struct drm_simple_display_pipe *pipe,
 	u32 cpl, tim2;
 	int ret;
 
-	if (connector->display_info.num_bus_formats == 1 &&
-	    connector->display_info.bus_formats[0] == MEDIA_BUS_FMT_Y8_1X8)
-		grayscale = true;
-
 	ret = clk_set_rate(priv->clk, mode->clock * 1000);
 	if (ret) {
 		dev_err(drm->dev,
@@ -191,6 +187,10 @@ static void pl111_display_enable(struct drm_simple_display_pipe *pipe,
 		    DRM_BUS_FLAG_PIXDATA_DRIVE_NEGEDGE)
 			tim2 |= TIM2_IPC;
 
+		if (connector->display_info.num_bus_formats == 1 &&
+		    connector->display_info.bus_formats[0] == MEDIA_BUS_FMT_Y8_1X8)
+			grayscale = true;
+
 		/*
 		 * The AC pin bias frequency is set to max count when using
 		 * grayscale so at least once in a while we will reverse