[v4 6/7] drm/mediatek: change the dsi phytiming calculate method
Nicolas Boichat
drinkcat at chromium.org
Mon Jun 3 22:36:38 UTC 2019
On Sat, Jun 1, 2019 at 5:26 PM Jitao Shi <jitao.shi at mediatek.com> wrote:
>
> Change the method of frame rate calc which can get more accurate
> frame rate.
>
> data rate = pixel_clock * bit_per_pixel / lanes
> Adjust hfp_wc to adapt the additional phy_data
>
> if MIPI_DSI_MODE_VIDEO_BURST
> hfp_wc = hfp * bpp - data_phy_cycles * lanes - 12 - 6;
> else
> hfp_wc = hfp * bpp - data_phy_cycles * lanes - 12;
>
> Note:
> //(2: 1 for sync, 1 for phy idle)
> data_phy_cycles = T_hs_exit + T_lpx + T_hs_prepare + T_hs_zero + 2;
>
> bpp: bit per pixel
>
> Signed-off-by: Jitao Shi <jitao.shi at mediatek.com>
> Tested-by: Ryan Case <ryandcase at chromium.org>
> ---
> drivers/gpu/drm/mediatek/mtk_dsi.c | 122 ++++++++++++++++++++---------
> 1 file changed, 83 insertions(+), 39 deletions(-)
>
> diff --git a/drivers/gpu/drm/mediatek/mtk_dsi.c b/drivers/gpu/drm/mediatek/mtk_dsi.c
> index abf6ddec5db6..558727c60ba3 100644
> --- a/drivers/gpu/drm/mediatek/mtk_dsi.c
> +++ b/drivers/gpu/drm/mediatek/mtk_dsi.c
> @@ -144,12 +144,6 @@
> #define DATA_0 (0xff << 16)
> #define DATA_1 (0xff << 24)
>
> -#define T_LPX 5
> -#define T_HS_PREP 6
> -#define T_HS_TRAIL 8
> -#define T_HS_EXIT 7
> -#define T_HS_ZERO 10
> -
> #define NS_TO_CYCLE(n, c) ((n) / (c) + (((n) % (c)) ? 1 : 0))
>
> #define MTK_DSI_HOST_IS_READ(type) \
> @@ -158,6 +152,25 @@
> (type == MIPI_DSI_GENERIC_READ_REQUEST_2_PARAM) || \
> (type == MIPI_DSI_DCS_READ))
>
> +struct mtk_phy_timing {
> + u32 lpx;
> + u32 da_hs_prepare;
> + u32 da_hs_zero;
> + u32 da_hs_trail;
> +
> + u32 ta_go;
> + u32 ta_sure;
> + u32 ta_get;
> + u32 da_hs_exit;
> +
> + u32 clk_hs_zero;
> + u32 clk_hs_trail;
> +
> + u32 clk_hs_prepare;
> + u32 clk_hs_post;
> + u32 clk_hs_exit;
> +};
> +
> struct phy;
>
> struct mtk_dsi_driver_data {
> @@ -182,12 +195,13 @@ struct mtk_dsi {
> struct clk *digital_clk;
> struct clk *hs_clk;
>
> - u32 data_rate;
> + u64 data_rate;
As highlighted in
https://patchwork.kernel.org/patch/10949323/#22673829, this change
causes issues on 32-bit platforms.
>
> unsigned long mode_flags;
> enum mipi_dsi_pixel_format format;
> unsigned int lanes;
> struct videomode vm;
> + struct mtk_phy_timing phy_timing;
> int refcount;
> bool enabled;
> u32 irq_data;
> @@ -221,17 +235,36 @@ static void mtk_dsi_phy_timconfig(struct mtk_dsi *dsi)
> {
> u32 timcon0, timcon1, timcon2, timcon3;
> u32 ui, cycle_time;
> + struct mtk_phy_timing *timing = &dsi->phy_timing;
> +
> + ui = 1000000000 / dsi->data_rate;
> + cycle_time = 8000000000 / dsi->data_rate;
> +
> + timing->lpx = NS_TO_CYCLE(60, cycle_time);
> + timing->da_hs_prepare = NS_TO_CYCLE(40 + 5 * ui, cycle_time);
> + timing->da_hs_zero = NS_TO_CYCLE(110 + 6 * ui, cycle_time);
> + timing->da_hs_trail = NS_TO_CYCLE(80 + 4 * ui, cycle_time);
>
> - ui = 1000 / dsi->data_rate + 0x01;
> - cycle_time = 8000 / dsi->data_rate + 0x01;
> + timing->ta_go = 4 * timing->lpx;
> + timing->ta_sure = 3 * timing->lpx / 2;
> + timing->ta_get = 5 * timing->lpx;
> + timing->da_hs_exit = 2 * timing->lpx;
>
> - timcon0 = T_LPX | T_HS_PREP << 8 | T_HS_ZERO << 16 | T_HS_TRAIL << 24;
> - timcon1 = 4 * T_LPX | (3 * T_LPX / 2) << 8 | 5 * T_LPX << 16 |
> - T_HS_EXIT << 24;
> - timcon2 = ((NS_TO_CYCLE(0x64, cycle_time) + 0xa) << 24) |
> - (NS_TO_CYCLE(0x150, cycle_time) << 16);
> - timcon3 = NS_TO_CYCLE(0x40, cycle_time) | (2 * T_LPX) << 16 |
> - NS_TO_CYCLE(80 + 52 * ui, cycle_time) << 8;
> + timing->clk_hs_zero = NS_TO_CYCLE(336, cycle_time);
> + timing->clk_hs_trail = NS_TO_CYCLE(100, cycle_time) + 10;
> +
> + timing->clk_hs_prepare = NS_TO_CYCLE(64, cycle_time);
> + timing->clk_hs_post = NS_TO_CYCLE(80 + 52 * ui, cycle_time);
> + timing->clk_hs_exit = 2 * timing->lpx;
> +
> + timcon0 = timing->lpx | timing->da_hs_prepare << 8 |
> + timing->da_hs_zero << 16 | timing->da_hs_trail << 24;
> + timcon1 = timing->ta_go | timing->ta_sure << 8 |
> + timing->ta_get << 16 | timing->da_hs_exit << 24;
> + timcon2 = 1 << 8 | timing->clk_hs_zero << 16 |
> + timing->clk_hs_trail << 24;
> + timcon3 = timing->clk_hs_prepare | timing->clk_hs_post << 8 |
> + timing->clk_hs_exit << 16;
>
> writel(timcon0, dsi->regs + DSI_PHY_TIMECON0);
> writel(timcon1, dsi->regs + DSI_PHY_TIMECON1);
> @@ -418,7 +451,8 @@ static void mtk_dsi_config_vdo_timing(struct mtk_dsi *dsi)
> u32 horizontal_sync_active_byte;
> u32 horizontal_backporch_byte;
> u32 horizontal_frontporch_byte;
> - u32 dsi_tmp_buf_bpp;
> + u32 dsi_tmp_buf_bpp, data_phy_cycles;
> + struct mtk_phy_timing *timing = &dsi->phy_timing;
>
> struct videomode *vm = &dsi->vm;
>
> @@ -433,7 +467,8 @@ static void mtk_dsi_config_vdo_timing(struct mtk_dsi *dsi)
> writel(vm->vactive, dsi->regs + DSI_VACT_NL);
>
> if (dsi->driver_data->has_size_ctl)
> - writel(vm->vactive << 16 | vm->hactive, dsi->regs + DSI_SIZE_CON);
> + writel(vm->vactive << 16 | vm->hactive,
> + dsi->regs + DSI_SIZE_CON);
>
> horizontal_sync_active_byte = (vm->hsync_len * dsi_tmp_buf_bpp - 10);
>
> @@ -444,7 +479,34 @@ static void mtk_dsi_config_vdo_timing(struct mtk_dsi *dsi)
> horizontal_backporch_byte = ((vm->hback_porch + vm->hsync_len) *
> dsi_tmp_buf_bpp - 10);
>
> - horizontal_frontporch_byte = (vm->hfront_porch * dsi_tmp_buf_bpp - 12);
> + data_phy_cycles = timing->lpx + timing->da_hs_prepare +
> + timing->da_hs_zero + timing->da_hs_exit + 2;
> +
> + if (dsi->mode_flags & MIPI_DSI_MODE_VIDEO_BURST) {
> + if (vm->hfront_porch * dsi_tmp_buf_bpp >
> + data_phy_cycles * dsi->lanes + 18) {
> + horizontal_frontporch_byte = vm->hfront_porch *
> + dsi_tmp_buf_bpp -
> + data_phy_cycles *
> + dsi->lanes - 18;
> + } else {
> + DRM_WARN("HFP less than d-phy, FPS will under 60Hz\n");
> + horizontal_frontporch_byte = vm->hfront_porch *
> + dsi_tmp_buf_bpp;
> + }
> + } else {
> + if (vm->hfront_porch * dsi_tmp_buf_bpp >
> + data_phy_cycles * dsi->lanes + 12) {
> + horizontal_frontporch_byte = vm->hfront_porch *
> + dsi_tmp_buf_bpp -
> + data_phy_cycles *
> + dsi->lanes - 12;
> + } else {
> + DRM_WARN("HFP less than d-phy, FPS will under 60Hz\n");
> + horizontal_frontporch_byte = vm->hfront_porch *
> + dsi_tmp_buf_bpp;
> + }
> + }
>
> writel(horizontal_sync_active_byte, dsi->regs + DSI_HSA_WC);
> writel(horizontal_backporch_byte, dsi->regs + DSI_HBP_WC);
> @@ -544,8 +606,7 @@ static int mtk_dsi_poweron(struct mtk_dsi *dsi)
> {
> struct device *dev = dsi->dev;
> int ret;
> - u64 pixel_clock, total_bits;
> - u32 htotal, htotal_bits, bit_per_pixel, overhead_cycles, overhead_bits;
> + u32 bit_per_pixel;
>
> if (++dsi->refcount != 1)
> return 0;
> @@ -564,24 +625,7 @@ static int mtk_dsi_poweron(struct mtk_dsi *dsi)
> break;
> }
>
> - /**
> - * htotal_time = htotal * byte_per_pixel / num_lanes
> - * overhead_time = lpx + hs_prepare + hs_zero + hs_trail + hs_exit
> - * mipi_ratio = (htotal_time + overhead_time) / htotal_time
> - * data_rate = pixel_clock * bit_per_pixel * mipi_ratio / num_lanes;
> - */
> - pixel_clock = dsi->vm.pixelclock;
> - htotal = dsi->vm.hactive + dsi->vm.hback_porch + dsi->vm.hfront_porch +
> - dsi->vm.hsync_len;
> - htotal_bits = htotal * bit_per_pixel;
> -
> - overhead_cycles = T_LPX + T_HS_PREP + T_HS_ZERO + T_HS_TRAIL +
> - T_HS_EXIT;
> - overhead_bits = overhead_cycles * dsi->lanes * 8;
> - total_bits = htotal_bits + overhead_bits;
> -
> - dsi->data_rate = DIV_ROUND_UP_ULL(pixel_clock * total_bits,
> - htotal * dsi->lanes);
> + dsi->data_rate = dsi->vm.pixelclock * bit_per_pixel / dsi->lanes;
>
> ret = clk_set_rate(dsi->hs_clk, dsi->data_rate);
> if (ret < 0) {
> --
> 2.21.0
>
> _______________________________________________
> dri-devel mailing list
> dri-devel at lists.freedesktop.org
> https://lists.freedesktop.org/mailman/listinfo/dri-devel
More information about the dri-devel
mailing list