[PATCH v3 1/2] dt-bindings: display: panel: Add support for Raydium RM67191 panel

[Fabio Estevam]

Hi Robert,

On Thu, Jun 20, 2019 at 10:32 AM Robert Chiras <robert.chiras at nxp.com> wrote:
>
> Add dt-bindings documentation for Raydium RM67191 DSI panel.
>
> Signed-off-by: Robert Chiras <robert.chiras at nxp.com>
> Reviewed-by: Sam Ravnborg <sam at ravnborg.org>
> ---
>  .../bindings/display/panel/raydium,rm67191.txt     | 39 ++++++++++++++++++++++
>  1 file changed, 39 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/display/panel/raydium,rm67191.txt
>
> diff --git a/Documentation/devicetree/bindings/display/panel/raydium,rm67191.txt b/Documentation/devicetree/bindings/display/panel/raydium,rm67191.txt
> new file mode 100644
> index 0000000..52af272
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/display/panel/raydium,rm67191.txt
> @@ -0,0 +1,39 @@
> +Raydium RM67171 OLED LCD panel with MIPI-DSI protocol
> +
> +Required properties:
> +- compatible:          "raydium,rm67191"
> +- reg:                 virtual channel for MIPI-DSI protocol
> +                       must be <0>
> +- dsi-lanes:           number of DSI lanes to be used
> +                       must be <3> or <4>
> +- port:                input port node with endpoint definition as
> +                       defined in Documentation/devicetree/bindings/graph.txt;
> +                       the input port should be connected to a MIPI-DSI device
> +                       driver
> +
> +Optional properties:
> +- reset-gpios:         a GPIO spec for the RST_B GPIO pin
> +- width-mm:            see panel-common.txt
> +- height-mm:           see panel-common.txt
> +- video-mode:          0 - burst-mode
> +                       1 - non-burst with sync event
> +                       2 - non-burst with sync po ulse

No power-supply property?