[PATCH] drm/msm/adreno: Add A540 support

Jordan Crouse jcrouse at codeaurora.org
Tue May 28 20:45:05 UTC 2019


On Tue, May 28, 2019 at 10:06:12AM -0700, Jeffrey Hugo wrote:
> The A540 is a derivative of the A530, and is found in the MSM8998 SoC.
> 
> Signed-off-by: Jeffrey Hugo <jeffrey.l.hugo at gmail.com>
> ---
>  drivers/gpu/drm/msm/adreno/a5xx_gpu.c      | 22 +++++++
>  drivers/gpu/drm/msm/adreno/a5xx_power.c    | 76 +++++++++++++++++++++-
>  drivers/gpu/drm/msm/adreno/adreno_device.c | 18 +++++
>  drivers/gpu/drm/msm/adreno/adreno_gpu.h    |  6 ++
>  4 files changed, 119 insertions(+), 3 deletions(-)

This is awesome.  I'm glad we can finally check this off the list.

> diff --git a/drivers/gpu/drm/msm/adreno/a5xx_gpu.c b/drivers/gpu/drm/msm/adreno/a5xx_gpu.c
> index e5fcefa49f19..7ca8fde22fd8 100644
> --- a/drivers/gpu/drm/msm/adreno/a5xx_gpu.c
> +++ b/drivers/gpu/drm/msm/adreno/a5xx_gpu.c
> @@ -318,12 +318,19 @@ static const struct {
>  
>  void a5xx_set_hwcg(struct msm_gpu *gpu, bool state)
>  {
> +	struct adreno_gpu *adreno_gpu = to_adreno_gpu(gpu);
>  	unsigned int i;
>  
>  	for (i = 0; i < ARRAY_SIZE(a5xx_hwcg); i++)
>  		gpu_write(gpu, a5xx_hwcg[i].offset,
>  			state ? a5xx_hwcg[i].value : 0);
>  
> +	if (adreno_is_a540(adreno_gpu)) {
> +		gpu_write(gpu, REG_A5XX_RBBM_CLOCK_HYST_GPMU, 0x00000222);

I don't think this one is needed - we can just go with the one two lines below.

> +		gpu_write(gpu, REG_A5XX_RBBM_CLOCK_DELAY_GPMU, 0x00000770);
> +		gpu_write(gpu, REG_A5XX_RBBM_CLOCK_HYST_GPMU, 0x00000004);

Both of these need the state ? <value> : 0x0 hack to turn off HWCG if requested

> +	}
> +
>  	gpu_write(gpu, REG_A5XX_RBBM_CLOCK_CNTL, state ? 0xAAA8AA00 : 0);
>  	gpu_write(gpu, REG_A5XX_RBBM_ISDB_CNT, state ? 0x182 : 0x180);
>  }
> @@ -507,6 +514,9 @@ static int a5xx_hw_init(struct msm_gpu *gpu)
>  
>  	gpu_write(gpu, REG_A5XX_VBIF_ROUND_ROBIN_QOS_ARB, 0x00000003);
>  
> +	if (adreno_is_a540(adreno_gpu))
> +		gpu_write(gpu, REG_A5XX_VBIF_GATE_OFF_WRREQ_EN, 0x00000009);
> +
>  	/* Make all blocks contribute to the GPU BUSY perf counter */
>  	gpu_write(gpu, REG_A5XX_RBBM_PERFCTR_GPU_BUSY_MASKED, 0xFFFFFFFF);
>  
> @@ -592,6 +602,8 @@ static int a5xx_hw_init(struct msm_gpu *gpu)
>  	/* Set the highest bank bit */
>  	gpu_write(gpu, REG_A5XX_TPL1_MODE_CNTL, 2 << 7);
>  	gpu_write(gpu, REG_A5XX_RB_MODE_CNTL, 2 << 1);
> +	if (adreno_is_a540(adreno_gpu))
> +		gpu_write(gpu, REG_A5XX_UCHE_DBG_ECO_CNTL_2, 2);
>  
>  	/* Protect registers from the CP */
>  	gpu_write(gpu, REG_A5XX_CP_PROTECT_CNTL, 0x00000007);
> @@ -642,6 +654,16 @@ static int a5xx_hw_init(struct msm_gpu *gpu)
>  		REG_A5XX_RBBM_SECVID_TSB_TRUSTED_BASE_HI, 0x00000000);
>  	gpu_write(gpu, REG_A5XX_RBBM_SECVID_TSB_TRUSTED_SIZE, 0x00000000);
>  
> +	/*
> +	 * VPC corner case with local memory load kill leads to corrupt
> +	 * internal state. Normal Disable does not work for all a5x chips.
> +	 * So do the following setting to disable it.
> +	 */
> +	if (adreno_gpu->info->quirks & ADRENO_QUIRK_LMLOADKILL_DISABLE) {

This is a5xx only quirk but it applies to multiple 5xx targets so I think its
reasonable to identify it as a quirk and use it as such to make it easier on
future code porters.

> +		gpu_rmw(gpu, REG_A5XX_VPC_DBG_ECO_CNTL, 0, BIT(23));
> +		gpu_rmw(gpu, 0xE04, BIT(18), 0); /*REG_A5XX_HLSQ_DBG_ECO_CNTL*/

You should define and use REG_A5XX_HLSQ_DBG_ECO_CNTL symbolically. We can help
you do the envytools dance if you need.

> +	}
> +
>  	ret = adreno_hw_init(gpu);
>  	if (ret)
>  		return ret;
> diff --git a/drivers/gpu/drm/msm/adreno/a5xx_power.c b/drivers/gpu/drm/msm/adreno/a5xx_power.c
> index 70e65c94e525..5cb325c6eb8f 100644
> --- a/drivers/gpu/drm/msm/adreno/a5xx_power.c
> +++ b/drivers/gpu/drm/msm/adreno/a5xx_power.c
> @@ -32,6 +32,18 @@
>  #define AGC_POWER_CONFIG_PRODUCTION_ID 1
>  #define AGC_INIT_MSG_VALUE 0xBABEFACE
>  
> +/* AGC_LM_CONFIG (A540+) */
> +#define AGC_LM_CONFIG (136/4)
> +#define AGC_LM_CONFIG_GPU_VERSION_SHIFT 17
> +#define AGC_LM_CONFIG_ENABLE_GPMU_ADAPTIVE 1
> +#define AGC_LM_CONFIG_THROTTLE_DISABLE (2 << 8)
> +#define AGC_LM_CONFIG_ISENSE_ENABLE (1 << 4)
> +#define AGC_LM_CONFIG_ENABLE_ERROR (3 << 4)
> +#define AGC_LM_CONFIG_LLM_ENABLED (1 << 16)
> +#define AGC_LM_CONFIG_BCL_DISABLED (1 << 24)
> +
> +#define AGC_LEVEL_CONFIG (140/4)
> +
>  static struct {
>  	uint32_t reg;
>  	uint32_t value;
> @@ -116,7 +128,7 @@ static inline uint32_t _get_mvolts(struct msm_gpu *gpu, uint32_t freq)
>  }
>  
>  /* Setup thermal limit management */
> -static void a5xx_lm_setup(struct msm_gpu *gpu)
> +static void a530_lm_setup(struct msm_gpu *gpu)
>  {
>  	struct adreno_gpu *adreno_gpu = to_adreno_gpu(gpu);
>  	struct a5xx_gpu *a5xx_gpu = to_a5xx_gpu(adreno_gpu);
> @@ -165,6 +177,45 @@ static void a5xx_lm_setup(struct msm_gpu *gpu)
>  	gpu_write(gpu, AGC_INIT_MSG_MAGIC, AGC_INIT_MSG_VALUE);
>  }
>  
> +#define PAYLOAD_SIZE(_size) ((_size) * sizeof(u32))
> +#define LM_DCVS_LIMIT 1
> +#define LEVEL_CONFIG ~(0x303)
> +
> +static void a540_lm_setup(struct msm_gpu *gpu)
> +{
> +	struct adreno_gpu *adreno_gpu = to_adreno_gpu(gpu);
> +	u32 config;
> +
> +	/* The battery current limiter isn't enabled for A540 */
> +	config = AGC_LM_CONFIG_BCL_DISABLED;
> +	config |= adreno_gpu->rev.patchid << AGC_LM_CONFIG_GPU_VERSION_SHIFT;
> +
> +	/* For now disable GPMU side throttling */
> +	config |= AGC_LM_CONFIG_THROTTLE_DISABLE;
> +
> +	/* Until we get clock scaling 0 is always the active power level */
> +	gpu_write(gpu, REG_A5XX_GPMU_GPMU_VOLTAGE, 0x80000000 | 0);
> +
> +	/* Fixed at 6000 for now */
> +	gpu_write(gpu, REG_A5XX_GPMU_GPMU_PWR_THRESHOLD, 0x80000000 | 6000);
> +
> +	gpu_write(gpu, AGC_MSG_STATE, 0x80000001);
> +	gpu_write(gpu, AGC_MSG_COMMAND, AGC_POWER_CONFIG_PRODUCTION_ID);
> +
> +	gpu_write(gpu, AGC_MSG_PAYLOAD(0), 5448); //magic number?

They are all magic numbers but especially this number.  530 has the same.

<snip>

Jordan
-- 
The Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project


More information about the dri-devel mailing list