[PATCH v2 1/2] iommu: add support for drivers that manage iommu explicitly
robin.murphy at arm.com
Tue Sep 10 16:51:57 UTC 2019
On 10/09/2019 16:34, Rob Clark wrote:
> On Tue, Sep 10, 2019 at 1:14 AM Joerg Roedel <joro at 8bytes.org> wrote:
>> On Fri, Sep 06, 2019 at 02:44:01PM -0700, Rob Clark wrote:
>>> @@ -674,7 +674,7 @@ int iommu_group_add_device(struct iommu_group *group, struct device *dev)
>>> list_add_tail(&device->list, &group->devices);
>>> - if (group->domain)
>>> + if (group->domain && !(dev->driver && dev->driver->driver_manages_iommu))
>> Hmm, this code usually runs at enumeration time when no driver is
>> attached to the device. Actually it would be pretty dangerous when this
>> code runs while a driver is attached to the device. How does that change
>> make things work for you?
> I was seeing this get called via the path driver_probe_device() ->
> platform_dma_configure() -> of_dma_configure() -> of_iommu_configure()
> -> iommu_probe_device() -> ...
> The only cases I was seeing where dev->driver is NULL where a few
> places that drivers call of_dma_configure() on their own sub-devices.
> But maybe there are some other paths that I did not notice?
For the of_iommu flow, it very much depends on your DT layout and driver
probe order as to whether you catch the "proper" call from
iommu_bus_notifier()/iommu_bus_init() or the late "replay" from
of_iommu_configure(). I wouldn't make any assumptions of consistency.
More information about the dri-devel