[PATCH 10/60] drm/bridge: Add bridge driver for display connectors

[Tomi Valkeinen]

Hi Laurent,

On 07/07/2019 21:18, Laurent Pinchart wrote:
> Display connectors are modelled in DT as a device node, but have so far
> been handled manually in several bridge drivers. This resulted in
> duplicate code in several bridge drivers, with slightly different (and
> thus confusing) logics.
> 
> In order to fix this, implement a bridge driver for display connectors.
> The driver centralises logic for the DVI, HDMI, VGAn composite and
> S-video connectors and exposes corresponding bridge operations.
> 
> This driver in itself doesn't solve the issue completely, changes in
> bridge and display controller drivers are needed to make use of the new
> connector driver.
> 
> Signed-off-by: Laurent Pinchart <laurent.pinchart at ideasonboard.com>
> ---
>   drivers/gpu/drm/bridge/Kconfig             |  11 +
>   drivers/gpu/drm/bridge/Makefile            |   1 +
>   drivers/gpu/drm/bridge/display-connector.c | 327 +++++++++++++++++++++
>   3 files changed, 339 insertions(+)
>   create mode 100644 drivers/gpu/drm/bridge/display-connector.c


> +	dev_info(&pdev->dev,
> +		 "Found %s display connector '%s' %s DDC bus and %s HPD GPIO (ops 0x%x)\n",
> +		 display_connector_type_name(conn),
> +		 conn->label ? conn->label : "<unlabelled>",
> +		 conn->ddc ? "with" : "without",
> +		 conn->hpd_gpio ? "with" : "without",
> +		 conn->bridge.ops);

dev_dbg()?

  Tomi

-- 
Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki