[PATCH v2 01/14] phy/rockchip: inno-hdmi: use correct vco_div_5 macro on rk3328

[Jonas Karlman]

inno_hdmi_phy_rk3328_clk_set_rate() is using the RK3228 macro
when configuring vco_div_5 on RK3328.

Fix this by using correct vco_div_5 macro for RK3328.

Fixes: 53706a116863 ("phy: add Rockchip Innosilicon hdmi phy")
Signed-off-by: Jonas Karlman <jonas at kwiboo.se>
---
 drivers/phy/rockchip/phy-rockchip-inno-hdmi.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/phy/rockchip/phy-rockchip-inno-hdmi.c b/drivers/phy/rockchip/phy-rockchip-inno-hdmi.c
index 9ca20c947283..b0ac1d3ee390 100644
--- a/drivers/phy/rockchip/phy-rockchip-inno-hdmi.c
+++ b/drivers/phy/rockchip/phy-rockchip-inno-hdmi.c
@@ -790,8 +790,8 @@ static int inno_hdmi_phy_rk3328_clk_set_rate(struct clk_hw *hw,
 			 RK3328_PRE_PLL_POWER_DOWN);
 
 	/* Configure pre-pll */
-	inno_update_bits(inno, 0xa0, RK3228_PCLK_VCO_DIV_5_MASK,
-			 RK3228_PCLK_VCO_DIV_5(cfg->vco_div_5_en));
+	inno_update_bits(inno, 0xa0, RK3328_PCLK_VCO_DIV_5_MASK,
+			 RK3328_PCLK_VCO_DIV_5(cfg->vco_div_5_en));
 	inno_write(inno, 0xa1, RK3328_PRE_PLL_PRE_DIV(cfg->prediv));
 
 	val = RK3328_SPREAD_SPECTRUM_MOD_DISABLE;
-- 
2.17.1