[PATCH RFT v2 1/3] drm/panfrost: enable devfreq based the "operating-points-v2" property

[Martin Blumenstingl]

Decouple the check to see whether we want to enable devfreq for the GPU
from dev_pm_opp_set_regulators(). This is preparation work for adding
back support for regulator control (which means we need to call
dev_pm_opp_set_regulators() before dev_pm_opp_of_add_table(), which
means having a check for "is devfreq enabled" that is not tied to
dev_pm_opp_of_add_table() makes things easier).

Signed-off-by: Martin Blumenstingl <martin.blumenstingl at googlemail.com>
---
 drivers/gpu/drm/panfrost/panfrost_devfreq.c | 9 ++++++---
 1 file changed, 6 insertions(+), 3 deletions(-)

diff --git a/drivers/gpu/drm/panfrost/panfrost_devfreq.c b/drivers/gpu/drm/panfrost/panfrost_devfreq.c
index 413987038fbf..1471588763ce 100644
--- a/drivers/gpu/drm/panfrost/panfrost_devfreq.c
+++ b/drivers/gpu/drm/panfrost/panfrost_devfreq.c
@@ -5,6 +5,7 @@
 #include <linux/platform_device.h>
 #include <linux/pm_opp.h>
 #include <linux/clk.h>
+#include <linux/property.h>
 #include <linux/regulator/consumer.h>
 
 #include "panfrost_device.h"
@@ -79,10 +80,12 @@ int panfrost_devfreq_init(struct panfrost_device *pfdev)
 	struct devfreq *devfreq;
 	struct thermal_cooling_device *cooling;
 
-	ret = dev_pm_opp_of_add_table(dev);
-	if (ret == -ENODEV) /* Optional, continue without devfreq */
+	if (!device_property_present(dev, "operating-points-v2"))
+		/* Optional, continue without devfreq */
 		return 0;
-	else if (ret)
+
+	ret = dev_pm_opp_of_add_table(dev);
+	if (ret)
 		return ret;
 
 	panfrost_devfreq_reset(pfdev);
-- 
2.24.1