[PATCH v4 14/20] backlight: cr_bllcd: introduce backlight_is_blank()

[Sam Ravnborg]

The cr_bllcd uses the FB_BLANK states as brightness.
This results in brightness value equals 0 that turn on
the display and 4 that turn off the display.
Simplify the logic but keep current behaviour
as userspace may expect brightness set to 0 to turn on the display.

Signed-off-by: Sam Ravnborg <sam at ravnborg.org>
Cc: Lee Jones <lee.jones at linaro.org>
Cc: Daniel Thompson <daniel.thompson at linaro.org>
Cc: Jingoo Han <jingoohan1 at gmail.com>
---
 drivers/video/backlight/cr_bllcd.c | 14 ++++----------
 1 file changed, 4 insertions(+), 10 deletions(-)

diff --git a/drivers/video/backlight/cr_bllcd.c b/drivers/video/backlight/cr_bllcd.c
index 4624b7b7c6a6..edca5fee9689 100644
--- a/drivers/video/backlight/cr_bllcd.c
+++ b/drivers/video/backlight/cr_bllcd.c
@@ -63,22 +63,16 @@ static int cr_backlight_set_intensity(struct backlight_device *bd)
 	u32 addr = gpio_bar + CRVML_PANEL_PORT;
 	u32 cur = inl(addr);
 
-	if (bd->props.power == FB_BLANK_UNBLANK)
-		intensity = FB_BLANK_UNBLANK;
-	if (bd->props.fb_blank == FB_BLANK_UNBLANK)
-		intensity = FB_BLANK_UNBLANK;
-	if (bd->props.power == FB_BLANK_POWERDOWN)
-		intensity = FB_BLANK_POWERDOWN;
-	if (bd->props.fb_blank == FB_BLANK_POWERDOWN)
+	if (backlight_is_blank(bd))
 		intensity = FB_BLANK_POWERDOWN;
 
-	if (intensity == FB_BLANK_UNBLANK) { /* FULL ON */
+	if (intensity != FB_BLANK_POWERDOWN) { /* FULL ON */
 		cur &= ~CRVML_BACKLIGHT_OFF;
 		outl(cur, addr);
-	} else if (intensity == FB_BLANK_POWERDOWN) { /* OFF */
+	} else { /* OFF */
 		cur |= CRVML_BACKLIGHT_OFF;
 		outl(cur, addr);
-	} /* anything else, don't bother */
+	}
 
 	return 0;
 }
-- 
2.25.1