[PATCH v3 07/21] drm/bridge: tc358767: add detect bridge operation

[Laurent Pinchart]

Hi Sam,

Thank you for the patch.

On Fri, Jul 03, 2020 at 09:24:03PM +0200, Sam Ravnborg wrote:
> Prepare the bridge driver for chained operation by adding
> support for the detect operation.
> 
> Signed-off-by: Sam Ravnborg <sam at ravnborg.org>
> Cc: Andrzej Hajda <a.hajda at samsung.com>
> Cc: Neil Armstrong <narmstrong at baylibre.com>
> Cc: Laurent Pinchart <Laurent.pinchart at ideasonboard.com>
> Cc: Jonas Karlman <jonas at kwiboo.se>
> Cc: Jernej Skrabec <jernej.skrabec at siol.net>
> ---
>  drivers/gpu/drm/bridge/tc358767.c | 16 +++++++++++++---
>  1 file changed, 13 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/gpu/drm/bridge/tc358767.c b/drivers/gpu/drm/bridge/tc358767.c
> index 08d483664258..85973ae728db 100644
> --- a/drivers/gpu/drm/bridge/tc358767.c
> +++ b/drivers/gpu/drm/bridge/tc358767.c
> @@ -1353,10 +1353,9 @@ static const struct drm_connector_helper_funcs tc_connector_helper_funcs = {
>  	.get_modes = tc_connector_get_modes,
>  };
>  
> -static enum drm_connector_status tc_connector_detect(struct drm_connector *connector,
> -						     bool force)
> +static enum drm_connector_status tc_bridge_detect(struct drm_bridge *bridge)
>  {
> -	struct tc_data *tc = connector_to_tc(connector);
> +	struct tc_data *tc = bridge_to_tc(bridge);
>  	bool conn;
>  	u32 val;
>  	int ret;
> @@ -1380,6 +1379,14 @@ static enum drm_connector_status tc_connector_detect(struct drm_connector *conne
>  		return connector_status_disconnected;
>  }
>  
> +static enum drm_connector_status
> +tc_connector_detect(struct drm_connector *connector, bool force)
> +{
> +	struct tc_data *tc = connector_to_tc(connector);
> +
> +	return tc_bridge_detect(&tc->bridge);
> +}
> +
>  static const struct drm_connector_funcs tc_connector_funcs = {
>  	.detect = tc_connector_detect,
>  	.fill_modes = drm_helper_probe_single_connector_modes,
> @@ -1444,6 +1451,7 @@ static const struct drm_bridge_funcs tc_bridge_funcs = {
>  	.enable = tc_bridge_enable,
>  	.disable = tc_bridge_disable,
>  	.mode_fixup = tc_bridge_mode_fixup,
> +	.detect = tc_bridge_detect,
>  };
>  
>  static bool tc_readable_reg(struct device *dev, unsigned int reg)
> @@ -1677,6 +1685,8 @@ static int tc_probe(struct i2c_client *client, const struct i2c_device_id *id)
>  		return ret;
>  
>  	tc->bridge.funcs = &tc_bridge_funcs;
> +	tc->bridge.ops = DRM_BRIDGE_OP_DETECT;

I think you should set DRM_BRIDGE_OP_DETECT only when tc->hpd_pin is
valid. I would also move the if (tc->hpd_pin < 0) case from
tc_bridge_detect to +tc_connector_detect.

> +
>  	tc->bridge.of_node = dev->of_node;
>  	drm_bridge_add(&tc->bridge);
>  

-- 
Regards,

Laurent Pinchart