[PATCH v5 08/16] pwm: crc: Fix off-by-one error in the clock-divider calculations

Hans de Goede hdegoede at redhat.com
Fri Jul 17 13:37:45 UTC 2020


The CRC PWM controller has a clock-divider which divides the clock with
a value between 1-128. But as can seen from the PWM_DIV_CLK_xxx
defines, this range maps to a register value of 0-127.

So after calculating the clock-divider we must subtract 1 to get the
register value, unless the requested frequency was so high that the
calculation has already resulted in a (rounded) divider value of 0.

Note that before this fix, setting a period of PWM_MAX_PERIOD_NS which
corresponds to the max. divider value of 128 could have resulted in a
bug where the code would use 128 as divider-register value which would
have resulted in an actual divider value of 0 (and the enable bit being
set). A rounding error stopped this bug from actually happen. This
same rounding error means that after the subtraction of 1 it is impossible
to set the divider to 128. Also bump PWM_MAX_PERIOD_NS by 1 ns to allow
setting a divider of 128 (register-value 127).

Signed-off-by: Hans de Goede <hdegoede at redhat.com>
---
Changes in v3:
- Introduce crc_pwm_calc_clk_div() here instead of later in the patch-set
  to reduce the amount of churn in the patch-set a bit
---
 drivers/pwm/pwm-crc.c | 17 ++++++++++++++---
 1 file changed, 14 insertions(+), 3 deletions(-)

diff --git a/drivers/pwm/pwm-crc.c b/drivers/pwm/pwm-crc.c
index c056eb9b858c..44ec7d5b63e1 100644
--- a/drivers/pwm/pwm-crc.c
+++ b/drivers/pwm/pwm-crc.c
@@ -22,7 +22,7 @@
 #define PWM_MAX_LEVEL		0xFF
 
 #define PWM_BASE_CLK_MHZ	6	/* 6 MHz */
-#define PWM_MAX_PERIOD_NS	5461333	/* 183 Hz */
+#define PWM_MAX_PERIOD_NS	5461334	/* 183 Hz */
 
 /**
  * struct crystalcove_pwm - Crystal Cove PWM controller
@@ -39,6 +39,18 @@ static inline struct crystalcove_pwm *to_crc_pwm(struct pwm_chip *pc)
 	return container_of(pc, struct crystalcove_pwm, chip);
 }
 
+static int crc_pwm_calc_clk_div(int period_ns)
+{
+	int clk_div;
+
+	clk_div = PWM_BASE_CLK_MHZ * period_ns / (256 * NSEC_PER_USEC);
+	/* clk_div 1 - 128, maps to register values 0-127 */
+	if (clk_div > 0)
+		clk_div--;
+
+	return clk_div;
+}
+
 static int crc_pwm_enable(struct pwm_chip *c, struct pwm_device *pwm)
 {
 	struct crystalcove_pwm *crc_pwm = to_crc_pwm(c);
@@ -68,11 +80,10 @@ static int crc_pwm_config(struct pwm_chip *c, struct pwm_device *pwm,
 	}
 
 	if (pwm_get_period(pwm) != period_ns) {
-		int clk_div;
+		int clk_div = crc_pwm_calc_clk_div(period_ns);
 
 		/* changing the clk divisor, need to disable fisrt */
 		crc_pwm_disable(c, pwm);
-		clk_div = PWM_BASE_CLK_MHZ * period_ns / (256 * NSEC_PER_USEC);
 
 		regmap_write(crc_pwm->regmap, PWM0_CLK_DIV,
 					clk_div | PWM_OUTPUT_ENABLE);
-- 
2.26.2



More information about the dri-devel mailing list