[PATCH 1/3] rapidio: Replace 'select' DMAENGINES 'with depends on'

[Laurent Pinchart]

Hi Sam,

On Wed, Jul 29, 2020 at 06:43:26PM +0200, Sam Ravnborg wrote:
> On Wed, Jul 29, 2020 at 07:29:08PM +0300, Laurent Pinchart wrote:
> > Enabling a whole subsystem from a single driver 'select' is frowned
> > upon and won't be accepted in new drivers, that need to use 'depends on'
> > instead. Existing selection of DMAENGINES will then cause circular
> > dependencies. Replace them with a dependency.
> > 
> > Signed-off-by: Laurent Pinchart <laurent.pinchart at ideasonboard.com>
> > Acked-by: Randy Dunlap <rdunlap at infradead.org>
> > ---
> >  drivers/rapidio/Kconfig | 2 +-
> >  1 file changed, 1 insertion(+), 1 deletion(-)
> > 
> > diff --git a/drivers/rapidio/Kconfig b/drivers/rapidio/Kconfig
> > index e4c422d806be..b9f8514909bf 100644
> > --- a/drivers/rapidio/Kconfig
> > +++ b/drivers/rapidio/Kconfig
> > @@ -37,7 +37,7 @@ config RAPIDIO_ENABLE_RX_TX_PORTS
> >  config RAPIDIO_DMA_ENGINE
> >  	bool "DMA Engine support for RapidIO"
> >  	depends on RAPIDIO
> > -	select DMADEVICES
> > +	depends on DMADEVICES
>
> $subject and changlog talks about DMAENGINES but the patch touches DMADEVICES??

Clearly a typo in the subject line, it should be DMADEVICES. I'll wait a
little bit to see if there are more comments, and will send a v2.

> >  	select DMA_ENGINE
> >  	help
> >  	  Say Y here if you want to use DMA Engine frameork for RapidIO data

-- 
Regards,

Laurent Pinchart