[PATCH v5 06/13] drm/panel: st7703: Prepare for supporting multiple panels
Ondrej Jirman
megous at megous.com
Fri Jun 26 00:55:54 UTC 2020
Parametrize the driver so that it can support more panels based
on st7703 controller.
Signed-off-by: Ondrej Jirman <megous at megous.com>
---
drivers/gpu/drm/panel/panel-sitronix-st7703.c | 43 +++++++++++++------
1 file changed, 31 insertions(+), 12 deletions(-)
diff --git a/drivers/gpu/drm/panel/panel-sitronix-st7703.c b/drivers/gpu/drm/panel/panel-sitronix-st7703.c
index 511af659f273..08cbc316266c 100644
--- a/drivers/gpu/drm/panel/panel-sitronix-st7703.c
+++ b/drivers/gpu/drm/panel/panel-sitronix-st7703.c
@@ -13,6 +13,7 @@
#include <linux/media-bus-format.h>
#include <linux/mod_devicetable.h>
#include <linux/module.h>
+#include <linux/of_device.h>
#include <linux/regulator/consumer.h>
#include <video/display_timing.h>
@@ -56,6 +57,15 @@ struct st7703 {
bool prepared;
struct dentry *debugfs;
+ const struct st7703_panel_desc *desc;
+};
+
+struct st7703_panel_desc {
+ const struct drm_display_mode *mode;
+ unsigned int lanes;
+ unsigned long mode_flags;
+ enum mipi_dsi_pixel_format format;
+ int (*init_sequence)(struct st7703 *ctx);
};
static inline struct st7703 *panel_to_st7703(struct drm_panel *panel)
@@ -148,7 +158,7 @@ static int st7703_enable(struct drm_panel *panel)
struct st7703 *ctx = panel_to_st7703(panel);
int ret;
- ret = jh057n_init_sequence(ctx);
+ ret = ctx->desc->init_sequence(ctx);
if (ret < 0) {
DRM_DEV_ERROR(ctx->dev, "Panel init sequence failed: %d\n",
ret);
@@ -216,7 +226,7 @@ static int st7703_prepare(struct drm_panel *panel)
return ret;
}
-static const struct drm_display_mode default_mode = {
+static const struct drm_display_mode jh057n00900_mode = {
.hdisplay = 720,
.hsync_start = 720 + 90,
.hsync_end = 720 + 90 + 20,
@@ -232,17 +242,26 @@ static const struct drm_display_mode default_mode = {
.height_mm = 130,
};
+struct st7703_panel_desc jh057n00900_panel_desc = {
+ .mode = &jh057n00900_mode,
+ .lanes = 4,
+ .mode_flags = MIPI_DSI_MODE_VIDEO |
+ MIPI_DSI_MODE_VIDEO_BURST | MIPI_DSI_MODE_VIDEO_SYNC_PULSE,
+ .format = MIPI_DSI_FMT_RGB888,
+ .init_sequence = jh057n_init_sequence,
+};
+
static int st7703_get_modes(struct drm_panel *panel,
struct drm_connector *connector)
{
struct st7703 *ctx = panel_to_st7703(panel);
struct drm_display_mode *mode;
- mode = drm_mode_duplicate(connector->dev, &default_mode);
+ mode = drm_mode_duplicate(connector->dev, ctx->desc->mode);
if (!mode) {
DRM_DEV_ERROR(ctx->dev, "Failed to add mode %ux%u@%u\n",
- default_mode.hdisplay, default_mode.vdisplay,
- default_mode.vrefresh);
+ ctx->desc->mode->hdisplay, ctx->desc->mode->vdisplay,
+ ctx->desc->mode->vrefresh);
return -ENOMEM;
}
@@ -317,11 +336,11 @@ static int st7703_probe(struct mipi_dsi_device *dsi)
mipi_dsi_set_drvdata(dsi, ctx);
ctx->dev = dev;
+ ctx->desc = of_device_get_match_data(dev);
- dsi->lanes = 4;
- dsi->format = MIPI_DSI_FMT_RGB888;
- dsi->mode_flags = MIPI_DSI_MODE_VIDEO |
- MIPI_DSI_MODE_VIDEO_BURST | MIPI_DSI_MODE_VIDEO_SYNC_PULSE;
+ dsi->mode_flags = ctx->desc->mode_flags;
+ dsi->format = ctx->desc->format;
+ dsi->lanes = ctx->desc->lanes;
ctx->vcc = devm_regulator_get(dev, "vcc");
if (IS_ERR(ctx->vcc)) {
@@ -361,8 +380,8 @@ static int st7703_probe(struct mipi_dsi_device *dsi)
}
DRM_DEV_INFO(dev, "%ux%u@%u %ubpp dsi %udl - ready\n",
- default_mode.hdisplay, default_mode.vdisplay,
- default_mode.vrefresh,
+ ctx->desc->mode->hdisplay, ctx->desc->mode->vdisplay,
+ ctx->desc->mode->vrefresh,
mipi_dsi_pixel_format_to_bpp(dsi->format), dsi->lanes);
st7703_debugfs_init(ctx);
@@ -405,7 +424,7 @@ static int st7703_remove(struct mipi_dsi_device *dsi)
}
static const struct of_device_id st7703_of_match[] = {
- { .compatible = "rocktech,jh057n00900" },
+ { .compatible = "rocktech,jh057n00900", .data = &jh057n00900_panel_desc },
{ /* sentinel */ }
};
MODULE_DEVICE_TABLE(of, st7703_of_match);
--
2.27.0
More information about the dri-devel
mailing list