[PATCH 45/59] drm/kmb: Enable LCD interrupts
Anitha Chrisanthus
anitha.chrisanthus at intel.com
Tue Jun 30 21:27:57 UTC 2020
Enabled vblank interrupts for LCD.
Signed-off-by: Anitha Chrisanithus <anitha.chrisanthus at intel.com>
Reviewed-by: Bob Paauwe <bob.j.paauwe at intel.com>
---
drivers/gpu/drm/kmb/kmb_crtc.c | 35 +++++++++++++++--------------------
drivers/gpu/drm/kmb/kmb_drv.c | 41 +++++++++++++++++++++--------------------
drivers/gpu/drm/kmb/kmb_plane.c | 6 +++---
drivers/gpu/drm/kmb/kmb_regs.h | 2 +-
4 files changed, 40 insertions(+), 44 deletions(-)
diff --git a/drivers/gpu/drm/kmb/kmb_crtc.c b/drivers/gpu/drm/kmb/kmb_crtc.c
index 75e78d7..b617507 100644
--- a/drivers/gpu/drm/kmb/kmb_crtc.c
+++ b/drivers/gpu/drm/kmb/kmb_crtc.c
@@ -61,7 +61,8 @@ static int kmb_crtc_enable_vblank(struct drm_crtc *crtc)
kmb_write_lcd(dev->dev_private, LCD_VSTATUS_COMPARE,
LCD_VSTATUS_COMPARE_VSYNC);
/* enable vertical interrupt */
- kmb_write_lcd(dev->dev_private, LCD_INT_ENABLE, LCD_INT_VERT_COMP);
+ kmb_set_bitmask_lcd(dev->dev_private, LCD_INT_ENABLE,
+ LCD_INT_VERT_COMP);
return 0;
}
@@ -72,13 +73,9 @@ static void kmb_crtc_disable_vblank(struct drm_crtc *crtc)
/*clear interrupt */
kmb_write_lcd(dev->dev_private, LCD_INT_CLEAR, LCD_INT_VERT_COMP);
/* disable vertical interrupt */
- kmb_write_lcd(dev->dev_private, LCD_INT_ENABLE, 0);
+ kmb_clr_bitmask_lcd(dev->dev_private, LCD_INT_ENABLE,
+ LCD_INT_VERT_COMP);
-/* TBD
- * set the BIT2 (VERTICAL_COMPARE_INTERRUPT) of the LCD_INT_ENABLE register
- * set the required bit LCD_VSTATUS_COMPARE register
- * Not sure if anything needs to be done in the ICB
- */
}
static const struct drm_crtc_funcs kmb_crtc_funcs = {
@@ -100,7 +97,7 @@ static void kmb_crtc_mode_set_nofb(struct drm_crtc *crtc)
struct videomode vm;
int vsync_start_offset;
int vsync_end_offset;
-#endif
+
/* initialize mipi */
kmb_dsi_hw_init(dev, m);
DRM_INFO("vfp= %d vbp= %d vsyc_len=%d hfp=%d hbp=%d hsync_len=%d\n",
@@ -110,7 +107,6 @@ static void kmb_crtc_mode_set_nofb(struct drm_crtc *crtc)
m->crtc_hsync_start - m->crtc_hdisplay,
m->crtc_htotal - m->crtc_hsync_end,
m->crtc_hsync_end - m->crtc_hsync_start);
-#ifdef LCD_TEST
// vm.vfront_porch = m->crtc_vsync_start - m->crtc_vdisplay;
vm.vfront_porch = 2;
// vm.vback_porch = m->crtc_vtotal - m->crtc_vsync_end;
@@ -174,7 +170,7 @@ static void kmb_crtc_atomic_enable(struct drm_crtc *crtc,
clk_prepare_enable(lcd->clk);
kmb_crtc_mode_set_nofb(crtc);
-// drm_crtc_vblank_on(crtc);
+ drm_crtc_vblank_on(crtc);
}
static void kmb_crtc_atomic_disable(struct drm_crtc *crtc,
@@ -185,33 +181,32 @@ static void kmb_crtc_atomic_disable(struct drm_crtc *crtc,
/* always disable planes on the CRTC that is being turned off */
drm_atomic_helper_disable_planes_on_crtc(old_state, false);
-// drm_crtc_vblank_off(crtc);
+ drm_crtc_vblank_off(crtc);
clk_disable_unprepare(lcd->clk);
}
static void kmb_crtc_atomic_begin(struct drm_crtc *crtc,
struct drm_crtc_state *state)
{
- /* TBD */
- /*disable vblank interrupts here
- * clear BIT 2 (VERTICAL_COMPARE_INTERRUPT) LCD_INT_ENABLE
- */
+ struct drm_device *dev = crtc->dev;
+
+ kmb_clr_bitmask_lcd(dev->dev_private, LCD_INT_ENABLE,
+ LCD_INT_VERT_COMP);
}
static void kmb_crtc_atomic_flush(struct drm_crtc *crtc,
struct drm_crtc_state *state)
{
- /* TBD */
- /*enable vblank interrupts after
- * set BIT 2 (VERTICAL_COMPARE_INTERRUPT) LCD_INT_ENABLE
- */
+ struct drm_device *dev = crtc->dev;
+
+ kmb_set_bitmask_lcd(dev->dev_private, LCD_INT_ENABLE,
+ LCD_INT_VERT_COMP);
spin_lock_irq(&crtc->dev->event_lock);
if (crtc->state->event)
drm_crtc_send_vblank_event(crtc, crtc->state->event);
crtc->state->event = NULL;
spin_unlock_irq(&crtc->dev->event_lock);
-
}
static const struct drm_crtc_helper_funcs kmb_crtc_helper_funcs = {
diff --git a/drivers/gpu/drm/kmb/kmb_drv.c b/drivers/gpu/drm/kmb/kmb_drv.c
index 64e45e7..d987529 100644
--- a/drivers/gpu/drm/kmb/kmb_drv.c
+++ b/drivers/gpu/drm/kmb/kmb_drv.c
@@ -147,10 +147,8 @@ static int kmb_load(struct drm_device *drm, unsigned long flags)
{
struct kmb_drm_private *dev_p = drm->dev_private;
struct platform_device *pdev = to_platform_device(drm->dev);
-#ifdef WIP
/*u32 version;*/
- int irq_lcd, irq_mipi;
-#endif
+ int irq_lcd;// irq_mipi;
int ret = 0;
unsigned long clk;
@@ -286,10 +284,9 @@ static int kmb_load(struct drm_device *drm, unsigned long flags)
kmb_set_bitmask_msscam(dev_p, MSS_CAM_CLK_CTRL, 0x1fff);
kmb_set_bitmask_msscam(dev_p, MSS_CAM_RSTN_CTRL, 0xffffffff);
#endif //KMB_CLOCKS
-#ifdef WIP
/* Register irqs here - section 17.3 in databook
* lists LCD at 79 and 82 for MIPI under MSS CPU -
- * firmware has to redirect it to A53
+ * firmware has redirected 79 to A53 IRQ 33
*/
DRM_INFO("platform_get_irq_byname %pOF\n", drm->dev->of_node);
@@ -299,14 +296,12 @@ static int kmb_load(struct drm_device *drm, unsigned long flags)
irq_lcd = platform_get_irq_byname(pdev, "irq_lcd");
if (irq_lcd < 0) {
DRM_ERROR("irq_lcd not found");
- return irq_lcd;
+ goto setup_fail;
}
pr_info("irq_lcd platform_get_irq = %d\n", irq_lcd);
- ret = request_irq(irq_lcd, kmb_isr, IRQF_SHARED, "irq_lcd", dev_p);
- dev_p->irq_lcd = irq_lcd;
-
+#ifdef WIP
/* Allocate MIPI interrupt resources, enable interrupt line,
* and setup IRQ handling
*/
@@ -342,19 +337,16 @@ static int kmb_load(struct drm_device *drm, unsigned long flags)
DRM_ERROR("failed to initialize DSI\n");
goto setup_fail;
}
-#ifdef WIP
- ret = drm_irq_install(drm, platform_get_irq(pdev, 0));
+ ret = drm_irq_install(drm, irq_lcd);
if (ret < 0) {
DRM_ERROR("failed to install IRQ handler\n");
goto irq_fail;
}
-#endif
+ dev_p->irq_lcd = irq_lcd;
return 0;
-#ifdef WIP
irq_fail:
drm_crtc_cleanup(&dev_p->crtc);
-#endif
setup_fail:
of_reserved_mem_device_release(drm->dev);
@@ -400,6 +392,11 @@ static irqreturn_t handle_lcd_irq(struct drm_device *dev)
kmb_write_lcd(dev->dev_private, LCD_INT_CLEAR,
LCD_INT_LINE_CMP);
}
+ if (status & LCD_INT_LAYER) {
+ /* clear layer interrupts */
+ kmb_write_lcd(dev->dev_private, LCD_INT_CLEAR, LCD_INT_LAYER);
+ }
+
if (status & LCD_INT_VERT_COMP) {
/* read VSTATUS */
val = kmb_read_lcd(dev->dev_private, LCD_VSTATUS);
@@ -419,23 +416,20 @@ static irqreturn_t handle_lcd_irq(struct drm_device *dev)
return IRQ_HANDLED;
}
+#ifdef MIPI_IRQ
static irqreturn_t handle_mipi_irq(struct drm_device *dev)
{
mipi_tx_handle_irqs(dev->dev_private);
return IRQ_HANDLED;
}
+#endif
static irqreturn_t kmb_isr(int irq, void *arg)
{
struct drm_device *dev = (struct drm_device *)arg;
- struct kmb_drm_private *dev_p = dev->dev_private;
irqreturn_t ret = IRQ_NONE;
- if (irq == dev_p->irq_lcd)
- ret = handle_lcd_irq(dev);
- else if (irq == dev_p->irq_mipi)
- ret = handle_mipi_irq(dev);
-
+ ret = handle_lcd_irq(dev);
return ret;
}
@@ -566,6 +560,12 @@ static int kmb_probe(struct platform_device *pdev)
/* Set the CRTC's port so that the encoder component can find it */
lcd->crtc.port = of_graph_get_port_by_id(dev->of_node, 0);
+ ret = drm_vblank_init(drm, drm->mode_config.num_crtc);
+ DRM_INFO("mode_config.num_crtc=%d\n", drm->mode_config.num_crtc);
+ if (ret < 0) {
+ DRM_ERROR("failed to initialize vblank\n");
+ goto err_vblank;
+ }
drm_mode_config_reset(drm);
drm_kms_helper_poll_init(drm);
@@ -582,6 +582,7 @@ static int kmb_probe(struct platform_device *pdev)
err_register:
drm_kms_helper_poll_fini(drm);
+err_vblank:
pm_runtime_disable(drm->dev);
err_free:
drm_mode_config_cleanup(drm);
diff --git a/drivers/gpu/drm/kmb/kmb_plane.c b/drivers/gpu/drm/kmb/kmb_plane.c
index 3cd9b0d..1990e8c 100644
--- a/drivers/gpu/drm/kmb/kmb_plane.c
+++ b/drivers/gpu/drm/kmb/kmb_plane.c
@@ -175,9 +175,9 @@ static void kmb_plane_atomic_disable(struct drm_plane *plane,
break;
}
- kmb_write_lcd(dev_p, LCD_LAYERn_DMA_CFG(plane_id),
- ~LCD_DMA_LAYER_ENABLE);
- kmb_write_lcd(dev_p, LCD_CONTROL, ~ctrl);
+ kmb_clr_bitmask_lcd(dev_p, LCD_LAYERn_DMA_CFG(plane_id),
+ LCD_DMA_LAYER_ENABLE);
+ kmb_clr_bitmask_lcd(dev_p, LCD_CONTROL, ctrl);
}
diff --git a/drivers/gpu/drm/kmb/kmb_regs.h b/drivers/gpu/drm/kmb/kmb_regs.h
index c80646a..0249ea5 100644
--- a/drivers/gpu/drm/kmb/kmb_regs.h
+++ b/drivers/gpu/drm/kmb/kmb_regs.h
@@ -107,7 +107,7 @@
#define LAYER3_DMA_IDLE (1<<24)
#define LAYER3_DMA_FIFO_OVERFLOW (1<<25)
#define LAYER3_DMA_FIFO_UNDERFLOW (1<<26)
-
+#define LCD_INT_LAYER (0x07fffff8)
#define LCD_INT_ENABLE (0x4 * 0x002)
#define LCD_INT_CLEAR (0x4 * 0x003)
#define LCD_LINE_COUNT (0x4 * 0x004)
--
2.7.4
More information about the dri-devel
mailing list