[PATCH 1/4] add dts node for drm panel driver ili9341 add dts i2c3 for stmpe touch add dts spi5 for gyro & ili9341

[dillon min]

Sam Ravnborg <sam at ravnborg.org> 于2020年5月2日周六 下午2:30写道：

> Hi dillon min
>
> > > okay, thanks alexandre, i will go through these docs. currently i'm on
> may
> > day holiday,  will be back at  next wensday.
> > after go back to work. i will separate this patch to five part with 9
> > patchs , should be more clear
> >
> > dts releated
> >     1,  ARM: dts: stm32: Add i2c3 node for stm32f429
> >     2,  ARM: dts: stm32: Add drm panel ili9341 nodes connect to ldtc
> > support for stm32f429-disco board
> >     3,  ARM: dts: stm32: Add stmpe811 touch screen support for
> > stm32f429-disco board
> >     4,  ARM: dts: stm32: Add l3gd20 gyroscope sensor support for
> > stm32f429-disco board
> >
> > clk releated
> >     1, clk: stm32: Fix ltdc loading hang in set clk rate, pll_hw set to
> > clks[PLL_VCO_SAI] but not clks[PLL_SAI]
> >     2, clk: stm32: Add CLK_IGNORE_UNUSED flags for ltdc, make sure ltdc
> clk
> > not be released after system startup
> >
> > spi releated
> >     1, spi: stm32: Add transfer mode SPI_SIMPLE_RX, SPI_3WIRE_RX support
> > for stm32f4
> >
> > drm releated
> >     1, drm/panel: Add panel driver ilitek-ili9341
> >
> > doc releated
> >      1, dt-bindings: display: panel: Add binding document for Ilitek
> Ili9341
>
> Patch separation looks good.
> Please cc: me on both the binding and the panel patches.
> The binding must be in DT Schema format (.yaml).
> See a lot of examples in drm-misc-next for inspiration.
>
> Looks forward to see/review your submission.
>
>         Sam
>

hi Sam,

just sumbmit a patchset about ltdc with ili-9341 support on stm32f429-disco
board, with yaml
documents inside as well.

thanks,

Dillon,
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.freedesktop.org/archives/dri-devel/attachments/20200506/d624c26d/attachment-0001.htm>