[PATCH v3 041/105] drm/vc4: crtc: Move HVS mode config to HVS file

[Eric Anholt]

On Wed, May 27, 2020 at 8:50 AM Maxime Ripard <maxime at cerno.tech> wrote:
>
> Signed-off-by: Maxime Ripard <maxime at cerno.tech>
> ---
>  drivers/gpu/drm/vc4/vc4_crtc.c | 272 +-------------------------------
>  drivers/gpu/drm/vc4/vc4_drv.h  |   5 +-
>  drivers/gpu/drm/vc4/vc4_hvs.c  | 298 ++++++++++++++++++++++++++++++++++-
>  3 files changed, 309 insertions(+), 266 deletions(-)


>  static void vc4_crtc_mode_set_nofb(struct drm_crtc *crtc)
>  {
> -       struct drm_device *dev = crtc->dev;
> -       struct vc4_dev *vc4 = to_vc4_dev(dev);
>         struct vc4_crtc *vc4_crtc = to_vc4_crtc(crtc);
>         struct vc4_crtc_state *vc4_state = to_vc4_crtc_state(crtc->state);
> -       struct drm_display_mode *mode = &crtc->state->adjusted_mode;
> -       bool interlace = mode->flags & DRM_MODE_FLAG_INTERLACE;
>         bool debug_dump_regs = false;
>
>         if (debug_dump_regs) {
> @@ -418,42 +372,10 @@ static void vc4_crtc_mode_set_nofb(struct drm_crtc *crtc)
>                 drm_print_regset32(&p, &vc4_crtc->regset);
>         }
>
> -       if (vc4_crtc->data->hvs_output == 2) {
> -               u32 dispctrl;
> -               u32 dsp3_mux;
> -
> -               /*
> -                * SCALER_DISPCTRL_DSP3 = X, where X < 2 means 'connect DSP3 to
> -                * FIFO X'.
> -                * SCALER_DISPCTRL_DSP3 = 3 means 'disable DSP 3'.
> -                *
> -                * DSP3 is connected to FIFO2 unless the transposer is
> -                * enabled. In this case, FIFO 2 is directly accessed by the
> -                * TXP IP, and we need to disable the FIFO2 -> pixelvalve1
> -                * route.
> -                */
> -               if (vc4_state->feed_txp)
> -                       dsp3_mux = VC4_SET_FIELD(3, SCALER_DISPCTRL_DSP3_MUX);
> -               else
> -                       dsp3_mux = VC4_SET_FIELD(2, SCALER_DISPCTRL_DSP3_MUX);
> -
> -               dispctrl = HVS_READ(SCALER_DISPCTRL) &
> -                          ~SCALER_DISPCTRL_DSP3_MUX_MASK;
> -               HVS_WRITE(SCALER_DISPCTRL, dispctrl | dsp3_mux);
> -       }

I just noticed, this block being moved looks like it should probably
have been removed as part of patch #33.  Cleaning this up I think will
impact the following patches.