[PATCH v2 0/4] drm/bridge: ti-sn65dsi86: Support EDID reading

[Sam Ravnborg]

Hi Stephen.

On Thu, Oct 29, 2020 at 06:17:34PM -0700, Stephen Boyd wrote:
> This patch series cleans up the DDC code a little bit so that
> it is more efficient time wise and supports grabbing the EDID
> of the eDP panel over the aux channel. I timed this on a board
> I have on my desk and it takes about 20ms to grab the EDID out
> of the panel and make sure it is valid.
> 
> The first two patches seem less controversial so I stuck them at
> the beginning. The third patch does the EDID reading and caches
> it so we don't have to keep grabbing it over and over again. And
> finally the last patch updates the reply field so that short
> reads and nacks over the channel are reflected properly instead of
> treating them as some sort of error that can't be discerned.
> 
> Stephen Boyd (4):
>   drm/bridge: ti-sn65dsi86: Combine register accesses in
>     ti_sn_aux_transfer()
>   drm/bridge: ti-sn65dsi86: Make polling a busy loop
>   drm/bridge: ti-sn65dsi86: Read EDID blob over DDC
>   drm/bridge: ti-sn65dsi86: Update reply on aux failures

Series looks good. You can add my a-b on the full series.
Acked-by: Sam Ravnborg <sam at ravnborg.org>

I can apply after Douglas have had a look at the patches he did not r-b
yet.

Any chance we can convince you to prepare this bridge driver for use in
a chained bridge setup where the connector is created by the display
driver and uses drm_bridge_funcs?

First step wuld be to introduce the use of a panel_bridge.
Then add get_edid to drm_bridge_funcs and maybe more helpers.

Then natural final step would be to move connector creation to the
display driver - see how other uses drm_bridge_connector_init() to do so
- it is relatively simple.

Should be doable - and reach out if you need some help.

	Sam


> 
>  drivers/gpu/drm/bridge/ti-sn65dsi86.c | 108 ++++++++++++++++++--------
>  1 file changed, 75 insertions(+), 33 deletions(-)
> 
> Cc: Douglas Anderson <dianders at chromium.org>
> Cc: Laurent Pinchart <Laurent.pinchart at ideasonboard.com>
> Cc: Jonas Karlman <jonas at kwiboo.se>
> Cc: Jernej Skrabec <jernej.skrabec at siol.net>
> Cc: Sean Paul <seanpaul at chromium.org>
> 
> base-commit: 3650b228f83adda7e5ee532e2b90429c03f7b9ec
> -- 
> Sent by a computer, using git, on the internet
> 
> _______________________________________________
> dri-devel mailing list
> dri-devel at lists.freedesktop.org
> https://lists.freedesktop.org/mailman/listinfo/dri-devel