[PATCH v3 0/4] drm/bridge: ti-sn65dsi86: Support EDID reading

[Stephen Boyd]

This patch series cleans up the DDC code a little bit so that
it is more efficient time wise and supports grabbing the EDID
of the eDP panel over the aux channel. I timed this on a board
I have on my desk and it takes about 20ms to grab the EDID out
of the panel and make sure it is valid.

The first two patches seem less controversial so I stuck them at
the beginning. The third patch does the EDID reading and caches
it so we don't have to keep grabbing it over and over again. And
finally the last patch updates the reply field so that short
reads and nacks over the channel are reflected properly instead of
treating them as some sort of error that can't be discerned.

Stephen Boyd (4):
  drm/bridge: ti-sn65dsi86: Combine register accesses in
    ti_sn_aux_transfer()
  drm/bridge: ti-sn65dsi86: Make polling a busy loop
  drm/bridge: ti-sn65dsi86: Read EDID blob over DDC
  drm/bridge: ti-sn65dsi86: Update reply on aux failures

 drivers/gpu/drm/bridge/ti-sn65dsi86.c | 103 ++++++++++++++++++--------
 1 file changed, 71 insertions(+), 32 deletions(-)

Cc: Douglas Anderson <dianders at chromium.org>
Cc: Laurent Pinchart <Laurent.pinchart at ideasonboard.com>
Cc: Jonas Karlman <jonas at kwiboo.se>
Cc: Jernej Skrabec <jernej.skrabec at siol.net>
Cc: Sean Paul <seanpaul at chromium.org>

base-commit: 3650b228f83adda7e5ee532e2b90429c03f7b9ec
-- 
Sent by a computer, using git, on the internet