[PATCH v7 15/47] dt-bindings: tegra30-actmon: Document OPP and interconnect properties

[Dmitry Osipenko]

Document EMC DFS OPP table and interconnect paths that will be used
for scaling of system's memory bandwidth based on memory utilization
statistics. Previously ACTMON was supposed to drive EMC clock rate
directly, but now it should do it using interconnect framework in order
to support shared voltage scaling in addition to the frequency scaling.

Reviewed-by: Rob Herring <robh at kernel.org>
Signed-off-by: Dmitry Osipenko <digetx at gmail.com>
---
 .../arm/tegra/nvidia,tegra30-actmon.txt       | 25 +++++++++++++++++++
 1 file changed, 25 insertions(+)

diff --git a/Documentation/devicetree/bindings/arm/tegra/nvidia,tegra30-actmon.txt b/Documentation/devicetree/bindings/arm/tegra/nvidia,tegra30-actmon.txt
index ea670a5d7ee3..897eedfa2bc8 100644
--- a/Documentation/devicetree/bindings/arm/tegra/nvidia,tegra30-actmon.txt
+++ b/Documentation/devicetree/bindings/arm/tegra/nvidia,tegra30-actmon.txt
@@ -18,8 +18,30 @@ clock-names. See ../../clock/clock-bindings.txt for details.
 ../../reset/reset.txt for details.
 - reset-names: Must include the following entries:
   - actmon
+- operating-points-v2: See ../bindings/opp/opp.txt for details.
+- interconnects: Should contain entries for memory clients sitting on
+                 MC->EMC memory interconnect path.
+- interconnect-names: Should include name of the interconnect path for each
+                      interconnect entry. Consult TRM documentation for
+                      information about available memory clients, see MEMORY
+                      CONTROLLER section.
+
+For each opp entry in 'operating-points-v2' table:
+- opp-supported-hw: bitfield indicating SoC speedo ID mask
+- opp-peak-kBps: peak bandwidth of the memory channel
 
 Example:
+	dfs_opp_table: opp-table {
+		compatible = "operating-points-v2";
+
+		opp at 12750000 {
+			opp-hz = /bits/ 64 <12750000>;
+			opp-supported-hw = <0x000F>;
+			opp-peak-kBps = <51000>;
+		};
+		...
+	};
+
 	actmon at 6000c800 {
 		compatible = "nvidia,tegra124-actmon";
 		reg = <0x0 0x6000c800 0x0 0x400>;
@@ -29,4 +51,7 @@ Example:
 		clock-names = "actmon", "emc";
 		resets = <&tegra_car 119>;
 		reset-names = "actmon";
+		operating-points-v2 = <&dfs_opp_table>;
+		interconnects = <&mc TEGRA124_MC_MPCORER &emc>;
+		interconnect-names = "cpu";
 	};
-- 
2.27.0