[PATCH v5 16/16] drm/panfrost: Increase the AS_ACTIVE polling timeout

[Boris Brezillon]

Experience has shown that 1ms is sometimes not enough, even when the GPU
is running at its maximum frequency, not to mention that an MMU operation
might take longer if the GPU is running at a lower frequency, which is
likely to be the case if devfreq is active.

Let's pick a significantly bigger timeout value (1ms -> 100ms) to be on
the safe side.

v5:
* New patch

Signed-off-by: Boris Brezillon <boris.brezillon at collabora.com>
---
 drivers/gpu/drm/panfrost/panfrost_mmu.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/gpu/drm/panfrost/panfrost_mmu.c b/drivers/gpu/drm/panfrost/panfrost_mmu.c
index 5267c3a1f02f..a32a3df5358e 100644
--- a/drivers/gpu/drm/panfrost/panfrost_mmu.c
+++ b/drivers/gpu/drm/panfrost/panfrost_mmu.c
@@ -34,7 +34,7 @@ static int wait_ready(struct panfrost_device *pfdev, u32 as_nr)
 	/* Wait for the MMU status to indicate there is no active command, in
 	 * case one is pending. */
 	ret = readl_relaxed_poll_timeout_atomic(pfdev->iomem + AS_STATUS(as_nr),
-		val, !(val & AS_STATUS_AS_ACTIVE), 10, 1000);
+		val, !(val & AS_STATUS_AS_ACTIVE), 10, 100000);
 
 	if (ret) {
 		/* The GPU hung, let's trigger a reset */
-- 
2.31.1