[PATCH 2/2] MIPS: ingenic: gcw0: SPI panel does not require active-high CS

[Paul Cercueil]

The NT39016 panel is a fun beast, even though the documentation states
that the CS line is active-low, it will work just fine if the CS line is
configured as active-high, but it won't work if the CS line is forced
low or forced high.

Since it did actually work with the spi-cs-high property, this is not a
bugfix, but we should nonetheless remove that property to match the
documentation.

Signed-off-by: Paul Cercueil <paul at crapouillou.net>
---
 arch/mips/boot/dts/ingenic/gcw0.dts | 1 -
 1 file changed, 1 deletion(-)

diff --git a/arch/mips/boot/dts/ingenic/gcw0.dts b/arch/mips/boot/dts/ingenic/gcw0.dts
index bc72304a2440..f4c04f2263ea 100644
--- a/arch/mips/boot/dts/ingenic/gcw0.dts
+++ b/arch/mips/boot/dts/ingenic/gcw0.dts
@@ -345,7 +345,6 @@ nt39016 at 0 {
 
 			spi-max-frequency = <3125000>;
 			spi-3wire;
-			spi-cs-high;
 
 			reset-gpios = <&gpe 2 GPIO_ACTIVE_LOW>;
 
-- 
2.30.1