[PATCH] backlight: qcom-wled: Use sink_addr for sync toggle
Marijn Suijten
marijn.suijten at somainline.org
Sun Mar 14 10:11:10 UTC 2021
From: Obeida Shamoun <oshmoun100 at googlemail.com>
WLED3_SINK_REG_SYNC is, as the name implies, a sink register offset.
Therefore, use the sink address as base instead of the ctrl address.
This fixes the sync toggle on wled4, which can be observed by the fact
that adjusting brightness now works.
It has no effect on wled3 because sink and ctrl base addresses are the
same. This allows adjusting the brightness without having to disable
then reenable the module.
Signed-off-by: Obeida Shamoun <oshmoun100 at googlemail.com>
Signed-off-by: Konrad Dybcio <konrad.dybcio at somainline.org>
Signed-off-by: Marijn Suijten <marijn.suijten at somainline.org>
---
drivers/video/backlight/qcom-wled.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/video/backlight/qcom-wled.c b/drivers/video/backlight/qcom-wled.c
index 091f07e7c145..fc8b443d10fd 100644
--- a/drivers/video/backlight/qcom-wled.c
+++ b/drivers/video/backlight/qcom-wled.c
@@ -336,13 +336,13 @@ static int wled3_sync_toggle(struct wled *wled)
unsigned int mask = GENMASK(wled->max_string_count - 1, 0);
rc = regmap_update_bits(wled->regmap,
- wled->ctrl_addr + WLED3_SINK_REG_SYNC,
+ wled->sink_addr + WLED3_SINK_REG_SYNC,
mask, mask);
if (rc < 0)
return rc;
rc = regmap_update_bits(wled->regmap,
- wled->ctrl_addr + WLED3_SINK_REG_SYNC,
+ wled->sink_addr + WLED3_SINK_REG_SYNC,
mask, WLED3_SINK_REG_SYNC_CLEAR);
return rc;
--
2.30.2
More information about the dri-devel
mailing list