[PATCH 25/30] ste_dma40.c: Few spello fixes

[Bhaskar Chowdhury]

s/ealier/earlier/
s/orignal/original/
s/manouver/maneuver/
s/transfer/transfer/
s/succees/success/

Signed-off-by: Bhaskar Chowdhury <unixbhaskar at gmail.com>
---
 drivers/dma/ste_dma40.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/dma/ste_dma40.c b/drivers/dma/ste_dma40.c
index 265d7c07b348..39fa2fb74057 100644
--- a/drivers/dma/ste_dma40.c
+++ b/drivers/dma/ste_dma40.c
@@ -155,7 +155,7 @@ static __maybe_unused u32 d40_backup_regs[] = {

 /*
  * since 9540 and 8540 has the same HW revision
- * use v4a for 9540 or ealier
+ * use v4a for 9540 or earlier
  * use v4b for 8540 or later
  * HW revision:
  * DB8500ed has revision 0
@@ -382,7 +382,7 @@ struct d40_desc {
  *
  * @base: The virtual address of LCLA. 18 bit aligned.
  * @dma_addr: DMA address, if mapped
- * @base_unaligned: The orignal kmalloc pointer, if kmalloc is used.
+ * @base_unaligned: The original kmalloc pointer, if kmalloc is used.
  * This pointer is only there for clean-up on error.
  * @pages: The number of pages needed for all physical channels.
  * Only used later for clean-up on error
@@ -1630,7 +1630,7 @@ static void dma_tasklet(struct tasklet_struct *t)

 	return;
  check_pending_tx:
-	/* Rescue manouver if receiving double interrupts */
+	/* Rescue maneuver if receiving double interrupts */
 	if (d40c->pending_tx > 0)
 		d40c->pending_tx--;
 	spin_unlock_irqrestore(&d40c->lock, flags);
@@ -1970,7 +1970,7 @@ static int d40_config_memcpy(struct d40_chan *d40c)
 		   dma_has_cap(DMA_SLAVE, cap)) {
 		d40c->dma_cfg = dma40_memcpy_conf_phy;

-		/* Generate interrrupt at end of transfer or relink. */
+		/* Generate interrupt at end of transfer or relink. */
 		d40c->dst_def_cfg |= BIT(D40_SREG_CFG_TIM_POS);

 		/* Generate interrupt on error. */
@@ -3415,7 +3415,7 @@ static int __init d40_lcla_allocate(struct d40_base *base)
 		base->lcla_pool.base = (void *)page_list[i];
 	} else {
 		/*
-		 * After many attempts and no succees with finding the correct
+		 * After many attempts and no success with finding the correct
 		 * alignment, try with allocating a big buffer.
 		 */
 		dev_warn(base->dev,
--
2.26.3