[PATCH v8 6/8] MIPS: DTS: CI20: Add DT nodes for HDMI setup

[H. Nikolaus Schaller]

Hi Gert,

> Am 25.11.2021 um 08:58 schrieb Geert Uytterhoeven <geert at linux-m68k.org>:
> 
> Hi Nikolaus,
> 
> On Wed, Nov 24, 2021 at 5:31 PM H. Nikolaus Schaller <hns at goldelico.com> wrote:
>>> Am 24.11.2021 um 17:21 schrieb Geert Uytterhoeven <geert at linux-m68k.org>:
>>> On Wed, Nov 24, 2021 at 5:19 PM H. Nikolaus Schaller <hns at goldelico.com> wrote:
>>>>> Am 23.11.2021 um 21:10 schrieb Paul Cercueil <paul at crapouillou.net>:
>>>>> Le mar., nov. 23 2021 at 19:13:59 +0100, H. Nikolaus Schaller <hns at goldelico.com> a écrit :
>>>>>> +    assigned-clock-rates = <48000000>, <0>, <54000000>, <0>, <27000000>;
>>>>>> };
>>>>>> &tcu {
>>>>>> @@ -509,6 +534,19 @@ pins_i2c4: i2c4 {
>>>>>>            bias-disable;
>>>>>>    };
>>>>>> +    pins_hdmi_ddc: hdmi_ddc {
>>>>>> +            function = "hdmi-ddc";
>>>>>> +            groups = "hdmi-ddc";
>>>>>> +            bias-disable;
>>>>>> +    };
>>>>>> +
>>>>>> +    /* switch to PF25 as gpio driving DDC_SDA low */
>>>>>> +    pins_hdmi_ddc_unwedge: hdmi_ddc {
>>>>>> +            function = "hdmi-ddc";
>>>>>> +            groups = "hdmi-ddc";
>>>>>> +            bias-disable;
>>>>>> +    };
>>>>> 
>>>>> Your pins_hdmi_ddc and pins_hdmi_ddc_unwedge are the exact same? You could just use the former and pass it to both pinctrl-0 and pinctrl-1.
>>>> 
>>>> This was forgotten to remove. We do not make use of the unwedge feature because I could not find out how to use pinctrl to switch this to gpio25 and drive it low.
>>> 
>>> Using gpio-hog?
>> 
>> well, AFAIR it activates the gpio permanently and is a propery of the gpio controller and not of pinmux.
> 
> Yes, hogs are permanently (ignoring DT overlay tricks).
> 
>> The driver assumes it can use pinmux state switching to drive the DDC_SDA line low on demand.
> 
> Add an optional wedge-gpios property for switching?

That would touch the synopsys driver core and does not appear to be required for jz4780 operation.
We just add a separate driver specialisation for some parameters and set up the device tree.

So it is beyond the scope of our work (neither needed, nor can we test it).
If you want to add that, please go ahead.

BR and thanks,
Nikolaus