[PATCH] drm: msm: fix building without CONFIG_COMMON_CLK
Dmitry Baryshkov
dmitry.baryshkov at linaro.org
Fri Oct 15 00:26:00 UTC 2021
On 13/10/2021 17:42, Arnd Bergmann wrote:
> From: Arnd Bergmann <arnd at arndb.de>
>
> When CONFIG_COMMON_CLOCK is disabled, the 8996 specific
> phy code is left out, which results in a link failure:
>
> ld: drivers/gpu/drm/msm/hdmi/hdmi_phy.o:(.rodata+0x3f0): undefined reference to `msm_hdmi_phy_8996_cfg'
>
> This was only exposed after it became possible to build
> test the driver without the clock interfaces.
>
> Make COMMON_CLK a hard dependency for compile testing,
> and simplify it a little based on that.
>
> Fixes: b3ed524f84f5 ("drm/msm: allow compile_test on !ARM")
> Reported-by: Randy Dunlap <rdunlap at infradead.org>
> Suggested-by: Geert Uytterhoeven <geert at linux-m68k.org>
> Signed-off-by: Arnd Bergmann <arnd at arndb.de>
This drops dependency on CONFIG_OF. While ARM64 selects OF, pure ARM
does not.
With that fixed:
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
> ---
> drivers/gpu/drm/msm/Kconfig | 2 +-
> drivers/gpu/drm/msm/Makefile | 6 +++---
> 2 files changed, 4 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/gpu/drm/msm/Kconfig b/drivers/gpu/drm/msm/Kconfig
> index f5107b6ded7b..cb204912e0f4 100644
> --- a/drivers/gpu/drm/msm/Kconfig
> +++ b/drivers/gpu/drm/msm/Kconfig
> @@ -4,8 +4,8 @@ config DRM_MSM
> tristate "MSM DRM"
> depends on DRM
> depends on ARCH_QCOM || SOC_IMX5 || COMPILE_TEST
> + depends on COMMON_CLK
> depends on IOMMU_SUPPORT
> - depends on (OF && COMMON_CLK) || COMPILE_TEST
> depends on QCOM_OCMEM || QCOM_OCMEM=n
> depends on QCOM_LLCC || QCOM_LLCC=n
> depends on QCOM_COMMAND_DB || QCOM_COMMAND_DB=n
> diff --git a/drivers/gpu/drm/msm/Makefile b/drivers/gpu/drm/msm/Makefile
> index 904535eda0c4..bbee22b54b0c 100644
> --- a/drivers/gpu/drm/msm/Makefile
> +++ b/drivers/gpu/drm/msm/Makefile
> @@ -23,8 +23,10 @@ msm-y := \
> hdmi/hdmi_i2c.o \
> hdmi/hdmi_phy.o \
> hdmi/hdmi_phy_8960.o \
> + hdmi/hdmi_phy_8996.o \
> hdmi/hdmi_phy_8x60.o \
> hdmi/hdmi_phy_8x74.o \
> + hdmi/hdmi_pll_8960.o \
> edp/edp.o \
> edp/edp_aux.o \
> edp/edp_bridge.o \
> @@ -37,6 +39,7 @@ msm-y := \
> disp/mdp4/mdp4_dtv_encoder.o \
> disp/mdp4/mdp4_lcdc_encoder.o \
> disp/mdp4/mdp4_lvds_connector.o \
> + disp/mdp4/mdp4_lvds_pll.o \
> disp/mdp4/mdp4_irq.o \
> disp/mdp4/mdp4_kms.o \
> disp/mdp4/mdp4_plane.o \
> @@ -117,9 +120,6 @@ msm-$(CONFIG_DRM_MSM_DP)+= dp/dp_aux.o \
> dp/dp_audio.o
>
> msm-$(CONFIG_DRM_FBDEV_EMULATION) += msm_fbdev.o
> -msm-$(CONFIG_COMMON_CLK) += disp/mdp4/mdp4_lvds_pll.o
> -msm-$(CONFIG_COMMON_CLK) += hdmi/hdmi_pll_8960.o
> -msm-$(CONFIG_COMMON_CLK) += hdmi/hdmi_phy_8996.o
>
> msm-$(CONFIG_DRM_MSM_HDMI_HDCP) += hdmi/hdmi_hdcp.o
>
>
--
With best wishes
Dmitry
More information about the dri-devel
mailing list