[PATCH v5 2/2] drm/bridge: lvds-codec: Add support for pixel data sampling edge select

[Marek Vasut]

The OnSemi FIN3385 Parallel-to-LVDS encoder has a dedicated input line to
select input pixel data sampling edge. Add DT property "pclk-sample", not
the same as the one used by display timings but rather the same as used by
media, and configure bus flags based on this DT property.

Signed-off-by: Marek Vasut <marex at denx.de>
Cc: Laurent Pinchart <laurent.pinchart at ideasonboard.com>
Cc: Rob Herring <robh+dt at kernel.org>
Cc: Sam Ravnborg <sam at ravnborg.org>
Cc: devicetree at vger.kernel.org
To: dri-devel at lists.freedesktop.org
---
V2: - Limit the pixelclk-active to encoders only
    - Update DT binding document
V3: - Determine whether this is encoder from connector, i.e.
      lvds_codec->connector_type == DRM_MODE_CONNECTOR_LVDS
V4: - Switch to pclk-sample. Note that the value of this is inverted,
      so all the existing users of pixelclk-active using previous
      previous version of this patch must be reworked
V5: Rebase on recent linux-next
---
 drivers/gpu/drm/bridge/lvds-codec.c | 15 +++++++++++++++
 1 file changed, 15 insertions(+)

diff --git a/drivers/gpu/drm/bridge/lvds-codec.c b/drivers/gpu/drm/bridge/lvds-codec.c
index f991842a161f..702ea803a743 100644
--- a/drivers/gpu/drm/bridge/lvds-codec.c
+++ b/drivers/gpu/drm/bridge/lvds-codec.c
@@ -21,6 +21,7 @@ struct lvds_codec {
 	struct device *dev;
 	struct drm_bridge bridge;
 	struct drm_bridge *panel_bridge;
+	struct drm_bridge_timings timings;
 	struct regulator *vcc;
 	struct gpio_desc *powerdown_gpio;
 	u32 connector_type;
@@ -119,6 +120,7 @@ static int lvds_codec_probe(struct platform_device *pdev)
 	struct device_node *bus_node;
 	struct drm_panel *panel;
 	struct lvds_codec *lvds_codec;
+	u32 val;
 	int ret;
 
 	lvds_codec = devm_kzalloc(dev, sizeof(*lvds_codec), GFP_KERNEL);
@@ -187,12 +189,25 @@ static int lvds_codec_probe(struct platform_device *pdev)
 		}
 	}
 
+	/*
+	 * Encoder might sample data on different clock edge than the display,
+	 * for example OnSemi FIN3385 has a dedicated strapping pin to select
+	 * the sampling edge.
+	 */
+	if (lvds_codec->connector_type == DRM_MODE_CONNECTOR_LVDS &&
+	    !of_property_read_u32(dev->of_node, "pclk-sample", &val)) {
+		lvds_codec->timings.input_bus_flags = val ?
+			DRM_BUS_FLAG_PIXDATA_SAMPLE_POSEDGE :
+			DRM_BUS_FLAG_PIXDATA_SAMPLE_NEGEDGE;
+	}
+
 	/*
 	 * The panel_bridge bridge is attached to the panel's of_node,
 	 * but we need a bridge attached to our of_node for our user
 	 * to look up.
 	 */
 	lvds_codec->bridge.of_node = dev->of_node;
+	lvds_codec->bridge.timings = &lvds_codec->timings;
 	drm_bridge_add(&lvds_codec->bridge);
 
 	platform_set_drvdata(pdev, lvds_codec);
-- 
2.33.0