[PATCH v2 2/2] drm/msm/dpu: Fix timeout issues on command mode panels

[Marijn Suijten]

On 2021-09-11 18:39:19, AngeloGioacchino Del Regno wrote:
> In function dpu_encoder_phys_cmd_wait_for_commit_done we are always
> checking if the relative CTL is started by waiting for an interrupt
> to fire: it is fine to do that, but then sometimes we call this
> function while the CTL is up and has never been put down, but that
> interrupt gets raised only when the CTL gets a state change from
> 0 to 1 (disabled to enabled), so we're going to wait for something
> that will never happen on its own.
> 
> Solving this while avoiding to restart the CTL is actually possible
> and can be done by just checking if it is already up and running
> when the wait_for_commit_done function is called: in this case, so,
> if the CTL was already running, we can say that the commit is done
> if the command transmission is complete (in other terms, if the
> interface has been flushed).
> 
> Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno at somainline.org>

This has unfortunately not solved any ctl_start timeout issues for me/us
on other platforms yet, but for the code:

Reviewed-by: Marijn Suijten <marijn.suijten at somainline.org>

> ---
>  drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c | 3 +++
>  1 file changed, 3 insertions(+)
> 
> diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c
> index aa01698d6b25..aa5d3b3cef15 100644
> --- a/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c
> +++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c
> @@ -682,6 +682,9 @@ static int dpu_encoder_phys_cmd_wait_for_commit_done(
>  	if (!dpu_encoder_phys_cmd_is_master(phys_enc))
>  		return 0;
>  
> +	if (phys_enc->hw_ctl->ops.is_started(phys_enc->hw_ctl))
> +		return dpu_encoder_phys_cmd_wait_for_tx_complete(phys_enc);
> +
>  	return _dpu_encoder_phys_cmd_wait_for_ctl_start(phys_enc);
>  }
>  
> -- 
> 2.32.0
>