[PATCH v4 2/4] drm: panel: Add Himax HX8394 panel controller driver

[Javier Martinez Canillas]

Hello Ondřej,

Thanks a lot for your comments.

On 12/30/22 16:40, Ondřej Jirman wrote:
> Hi Javier,
> 
> On Fri, Dec 30, 2022 at 12:31:52PM +0100, Javier Martinez Canillas wrote:
>> From: Kamil Trzciński <ayufan at ayufan.eu>
>>
>> The driver is for panels based on the Himax HX8394 controller, such as the
>> HannStar HSD060BHW4 720x1440 TFT LCD panel that uses a MIPI-DSI interface.
> 
> I see you've removed debug printks from enable/disable/prepare/unprepare

Yes, because as you said were debug printks. Feel free to propose adding the
debug printks if you consider useful for normal usage and not just for devel
purposes.

> hooks. Have you tested the driver thoroughly with various DRM apps,
> with DPM/suspend/resume, etc.?
>

I did not. I wasn't expecting suspend and resume to work on the PPP given its
support is quite minimal currently.
 
> The dw-mipi-dsi driver does some unorthodox things[1], that can lead to unbalanced
> calls to these functions in some situations, and that's why all these printks
> were there. To ensure the driver hooks are called correctly, while preparing
> the code for upstreaming. This lead to broken display in some situations during
> suspend/resume.
> 
> https://elixir.bootlin.com/linux/latest/source/drivers/gpu/drm/bridge/synopsys/dw-mipi-dsi.c#L868
>

This needs to be fixed in the dw-mipi-dsi driver then. But at least we will get
a panel-himax-hx8394 driver in mainline to avoid having to use downstream trees
for development and testing.

> Also, have you checked the clocks are actually configured correctly by the
> rk3399 cru driver? I have a lot of trouble with that, too. clk driver sometimes
> selects the fractional clock, but does not give it the necessary >20x difference
> between input/output clock rates. You'll only notice if you measure clock rates
> directly, by looking at actual refresh rate, by using some testing DRM app.
> Clock subsystem sometimes shuffles things around if you switch VOPs and use big
> VOP for mipi-dsi display, instead of the default small VOP.
>

I have not. Just verified that the display was working on my PPP and could start
a mutter wayland session. We could fix the clock configuration as follow-up IMO.

> I'll test this patchset in a few days against purely mainline code, but I'm
> pretty sure looking at the modes you use, that this will not work on some
> Pinephone Pro's, and will cause display corruption when you fix your clock
> setup, so that CRU actually outputs 74.25MHz as requested by the mode. (Which
> can be fixed by this patch https://github.com/megous/linux/commit/f7ee16f12ee8a44ee2472f2967ca27768106e00f)
> 

As mentioned, I prefer to make the support incremental. First having the panel
driver and then we can fix any remaining issue as follow-up patch series.

-- 
Best regards,

Javier Martinez Canillas
Core Platforms
Red Hat