[PATCH v2 13/22] drm/nouveau/kms: Remove redundant zpos initialisation

[Lyude Paul]

Reviewed-by: Lyude Paul <lyude at redhat.com>

I assume you'll handle pushing this yourself? (JFYI - using drm-misc for
pushing this is fine by me)

On Mon, 2022-02-21 at 10:59 +0100, Maxime Ripard wrote:
> The nouveau KMS driver will call drm_plane_create_zpos_property() with
> an init value depending on the plane purpose.
> 
> Since the initial value wasn't carried over in the state, the driver had
> to set it again in nv50_wndw_reset(). However, the helpers have been
> adjusted to set it properly at reset, so this is not needed anymore.
> 
> Cc: nouveau at lists.freedesktop.org
> Cc: Ben Skeggs <bskeggs at redhat.com>
> Cc: Karol Herbst <kherbst at redhat.com>
> Cc: Lyude Paul <lyude at redhat.com>
> Signed-off-by: Maxime Ripard <maxime at cerno.tech>
> ---
>  drivers/gpu/drm/nouveau/dispnv50/wndw.c | 2 --
>  1 file changed, 2 deletions(-)
> 
> diff --git a/drivers/gpu/drm/nouveau/dispnv50/wndw.c
> b/drivers/gpu/drm/nouveau/dispnv50/wndw.c
> index 133c8736426a..0c1a2ea0ed04 100644
> --- a/drivers/gpu/drm/nouveau/dispnv50/wndw.c
> +++ b/drivers/gpu/drm/nouveau/dispnv50/wndw.c
> @@ -635,8 +635,6 @@ nv50_wndw_reset(struct drm_plane *plane)
>                 plane->funcs->atomic_destroy_state(plane, plane->state);
>  
>         __drm_atomic_helper_plane_reset(plane, &asyw->state);
> -       plane->state->zpos = nv50_wndw_zpos_default(plane);
> -       plane->state->normalized_zpos = nv50_wndw_zpos_default(plane);
>  }
>  
>  static void

-- 
Cheers,
 Lyude Paul (she/her)
 Software Engineer at Red Hat