[PATCH v3] simplefb: Enable boot time VESA graphic mode selection.

[Michal Suchánek]

On Wed, Feb 23, 2022 at 07:13:07PM +0100, Javier Martinez Canillas wrote:
> On 2/23/22 18:12, Michal Suchánek wrote:
> > On Wed, Feb 23, 2022 at 05:54:54PM +0100, Javier Martinez Canillas wrote:
> 
> [snip]
> 
> >>
> >> Yes, that's what I tried to say. But your commit message says "To enable
> >> use of VESA modes with simplefb in legacy BIOS boot mode" and that isn't
> >> accurate AFAIU (unless you meant sysfb instead).
> > 
> >  config SYSFB_SIMPLEFB
> >         bool "Mark VGA/VBE/EFI FB as generic system framebuffer"
> >         depends on SYSFB
> > +       select BOOT_VESA_SUPPORT if X86
> > 
> > This to me means that it's simplefb specifically that requires it, not sysfb.
> > More precisely SYSFB_SIMPLEFB which is the simplefb implementation on top of
> > legacy BIOS.
> > 
> 
> Ok, I see what you meant. The fact that simplefb is what's named to the part
> of the sysfb driver that register the "simple-framebuffer" platform device
> and also the name of the fbdev driver that matches the "simple-framebuffer"
> is too confusing.
> 
> My point about the subject line remains thought, I would use something like:
> 
> firmware: sysfb: Enable boot time VESA graphic mode selection for simplefb

I see where the confusion comes from.

The efifb (and probably vesafb) has implicit unstated dependency on
sysfb. So the drivers that select BOOT_VESA_SUPPORT should instead
depend on SYSFB, and then SYSFB can select BOOT_VESA_SUPPORT, and it
will look much saner.

Thanks

Michal