Phyr Starter

[Thomas Zimmermann]

Hi

Am 10.01.22 um 20:34 schrieb Matthew Wilcox:
> TLDR: I want to introduce a new data type:
> 
> struct phyr {
>          phys_addr_t addr;
>          size_t len;
> };

Did you look at struct dma_buf_map? [1]

For graphics framebuffers, we have the problem that these buffers can be 
in I/O or system memory (and possibly move between them). Linux' 
traditional interfaces (memcpy_toio(), etc) don't deal with the 
differences well.

So we added struct dma_buf_map as an abstraction to the buffer address. 
There are interfaces for accessing and copying the data. I also have a 
patchset somewhere that adds caching information to the structure. 
struct dma_buf_map is for graphics, but really just another memory API.

When we introduced struct dma_buf_map we thought of additional use 
cases, but couldn't really find any at the time. Maybe what you're 
describing is that use case and struct dma_buf_map could be extended for 
this purpose.

Best regards
Thomas

[1] 
https://elixir.bootlin.com/linux/v5.16/source/include/linux/dma-buf-map.h#L115

> 
> and use it to replace bio_vec as well as using it to replace the array
> of struct pages used by get_user_pages() and friends.
> 
> ---
> 
> There are two distinct problems I want to address: doing I/O to memory
> which does not have a struct page and efficiently doing I/O to large
> blobs of physically contiguous memory, regardless of whether it has a
> struct page.  There are some other improvements which I regard as minor.
> 
> There are many types of memory that one might want to do I/O to that do
> not have a struct page, some examples:
>   - Memory on a graphics card (or other PCI card, but gfx seems to be
>     the primary provider of DRAM on the PCI bus today)
>   - DAX, or other pmem (there are some fake pages today, but this is
>     mostly a workaround for the IO problem today)
>   - Guest memory being accessed from the hypervisor (KVM needs to
>     create structpages to make this happen.  Xen doesn't ...)
> All of these kinds of memories can be addressed by the CPU and so also
> by a bus master.  That is, there is a physical address that the CPU
> can use which will address this memory, and there is a way to convert
> that to a DMA address which can be programmed into another device.
> There's no intent here to support memory which can be accessed by a
> complex scheme like writing an address to a control register and then
> accessing the memory through a FIFO; this is for memory which can be
> accessed by DMA and CPU loads and stores.
> 
> For get_user_pages() and friends, we currently fill an array of struct
> pages, each one representing PAGE_SIZE bytes.  For an application that
> is using 1GB hugepages, writing 2^18 entries is a significant overhead.
> It also makes drivers hard to write as they have to recoalesce the
> struct pages, even though the VM can tell it whether those 2^18 pages
> are contiguous.
> 
> On the minor side, struct phyr can represent any mappable chunk of memory.
> A bio_vec is limited to 2^32 bytes, while on 64-bit machines a phyr
> can represent larger than 4GB.  A phyr is the same size as a bio_vec
> on 64 bit (16 bytes), and the same size for 32-bit with PAE (12 bytes).
> It is smaller for 32-bit machines without PAE (8 bytes instead of 12).
> 
> Finally, it may be possible to stop using scatterlist to describe the
> input to the DMA-mapping operation.  We may be able to get struct
> scatterlist down to just dma_address and dma_length, with chaining
> handled through an enclosing struct.
> 
> I would like to see phyr replace bio_vec everywhere it's currently used.
> I don't have time to do that work now because I'm busy with folios.
> If someone else wants to take that on, I shall cheer from the sidelines.
> What I do intend to do is:
> 
>   - Add an interface to gup.c to pin/unpin N phyrs
>   - Add a sg_map_phyrs()
>     This will take an array of phyrs and allocate an sg for them
>   - Whatever else I need to do to make one RDMA driver happy with
>     this scheme
> 
> At that point, I intend to stop and let others more familiar with this
> area of the kernel continue the conversion of drivers.
> 
> P.S. If you've had the Prodigy song running through your head the whole
> time you've been reading this email ... I'm sorry / You're welcome.
> If people insist, we can rename this to phys_range or something boring,
> but I quite like the spelling of phyr with the pronunciation of "fire".

-- 
Thomas Zimmermann
Graphics Driver Developer
SUSE Software Solutions Germany GmbH
Maxfeldstr. 5, 90409 Nürnberg, Germany
(HRB 36809, AG Nürnberg)
Geschäftsführer: Ivo Totev
-------------- next part --------------
A non-text attachment was scrubbed...
Name: OpenPGP_signature
Type: application/pgp-signature
Size: 840 bytes
Desc: OpenPGP digital signature
URL: <https://lists.freedesktop.org/archives/dri-devel/attachments/20220111/80f14df8/attachment.sig>